MotoService Log
Moto Guzzi V7 Classic / Cafe / Special (750)
Example photo: Snowdog, Public domain, Wikimedia Commons
Moto Guzzi · Moto Guzzi V-twin, injected (2000-)

V7 Classic / Cafe / Special (750)

Library entry covers 2008-2012

11 factory 34 guideline

Published source

Moto Guzzi V7 Classic Service Station Manual 981078, Maintenance chart MAIN-23

Factory workshop manual. Covers V7 Classic (service station manual 981078).

Open the source

45 items for a 2008 model, grouped by interval the way a factory chart is laid out.

How this bike is built (what the schedule is based on)
Engine cycle
Four-stroke
Engine lubrication
Wet sump (oil in crankcase)
Oil filtration
Replaceable cartridge or spin-on filter
Valve gear
Overhead valve, pushrods, adjustable tappets
Ignition
Electronic (CDI / transistor / ECU)
Charging
Alternator / stator with rectifier
Battery
Wet cell (flooded lead-acid, needs topping up)
Fuel system
Fuel injection
Cooling
Air / oil cooled
Primary drive
Gear or chain inside engine, shares engine oil
Gearbox oil
Separate gearbox oil
Clutch control
Hand lever, cable
Final drive
Shaft
Front suspension
Telescopic fork
Rear suspension
Swingarm, twin shocks
Front brake
Disc, hydraulic
Rear brake
Disc, hydraulic
Wheels
Cast / alloy, tubeless
Sidecar
No sidecar
Maintenance schedule

2008 Moto Guzzi V7 Classic / Cafe / Special (750)

On the road: every 200 mi

1 item
  • Check engine oil level
    Pre-ride / on the road
    Guideline

    Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.

On the road: every 300 mi

2 items
  • Check lights, horn, brake light switches
    Pre-ride / on the road
    Guideline
  • Check tire pressures
    Pre-ride / on the road
    Guideline

Every 1,000 mi or 6 months

1 item
  • Inspect tire tread, sidewalls and date codes
    Wheels and tires
    Guideline

Every 3,000 mi or 12 months

7 items
  • Check throttle cable(s) free play and return
    Fuel and air
    Guideline
  • Check steering head bearing adjustment
    Front end
    Guideline
  • Inspect fork seals, stanchions and fork boots
    Front end
    Guideline
  • Check footrests, pegs, rear brake and gear lever pivots
    Rear suspension and frame
    Guideline
  • Grease and check center / side stand and springs
    Rear suspension and frame
    Guideline
  • Check brake pads and discs
    Brakes
    Guideline
  • Check wheel bearings for play
    Wheels and tires
    Guideline

Every 4,000 mi or 12 months

2 items
  • Inspect, clean and gap spark plugs
    Engine
    Guideline
  • Adjust clutch free play, lubricate cable and lever pivot
    Primary and gearbox
    Guideline

Every 4,660 mi

7 items
  • Change engine oil
    Engine
    Factory

    Manual: Engine oil. Factory: Columns km x1000 1/7.5/15/22.5/30/37.5/45/52.5/60; first 1,000 km

  • Check and adjust valve clearances
    Engine
    Factory

    Manual: Valve clearance adjustment. Factory: First 1,000 km

  • Replace oil filter
    Engine
    Factory

    Manual: Engine oil filter. Factory: First 1,000 km

  • Replace spark plugs
    Engine
    Factory

    Manual: Spark plugs.

  • Synchronize throttle bodies
    Fuel and air
    Factory

    Manual: Cylinder synchronization.

  • Change gearbox oil
    Primary and gearbox
    Factory

    Manual: Gearbox oil. Factory: First 1,000 km

  • Change final drive (rear drive) oil
    Final drive
    Factory

    Manual: Final drive oil. Factory: First 1,000 km

Every 6,000 mi or 12 months

7 items
  • Clean / inspect air filter
    Fuel and air
    Guideline

    Mesh or oiled foam: clean and re-oil. Paper: blow out or replace. Some very early machines have no filter at all.

  • Check charging voltage and regulator / cut-out
    Ignition and electrics
    Guideline
  • Check final drive for leaks and bearing play
    Final drive
    Guideline
  • Check swingarm bushes for play
    Rear suspension and frame
    Guideline
  • Inspect rear shocks for leaks and damping
    Rear suspension and frame
    Guideline
  • Lubricate control cables and lever pivots
    Controls and cables
    Guideline
  • Lubricate speedometer / tachometer cables, check drive
    Controls and cables
    Guideline

    A dry speedo cable whips the needle and eventually kills the instrument.

Every 9,321 mi

1 item
  • Replace air filter element
    Fuel and air
    Factory

    Manual: Air filter. Factory: Inspect at 7,500 km intermediate services

Every 10,000 mi or 2 years

1 item
  • Compression test (or leak-down)
    Engine
    Guideline

Every 12,000 mi or 2 years

1 item
  • Grease swingarm pivot
    Rear suspension and frame
    Guideline

Every 12,427 mi or 2 years

1 item
  • Replace brake fluid
    Brakes
    Factory

    Manual: Brake fluid. Factory: Replace every 2 years or 20000 km (12427 miles)

Every 15,000 mi or 3 years

1 item
  • Change fork oil
    Front end
    Guideline

    Some early telescopic forks are grease filled or use very small oil quantities. Check your manual.

Every 20,000 mi or 4 years

3 items
  • Lubricate drive shaft splines / check U-joint
    Final drive
    Guideline
  • Repack / replace steering head bearings
    Front end
    Guideline

    Many old machines use loose balls in cups and cones. Taper roller conversions are common.

  • Repack / replace wheel bearings
    Wheels and tires
    Guideline

    Cup-and-cone and taper roller hubs need periodic repacking and adjustment.

Every 24,000 mi or 4 years

1 item
  • Replace fuel filter
    Fuel and air
    Guideline

Every 25,000 mi or 6 years

1 item
  • Replace swingarm bushes / bearings
    Rear suspension and frame
    Guideline

Every 30,000 mi or 6 years

1 item
  • Rebuild forks: seals, bushes, springs
    Front end
    Guideline

Every 6 months

1 item
  • Clean battery terminals, check charge and strap
    Ignition and electrics
    Guideline

Every 2 years

2 items
  • Inspect wiring, bullet connectors and ground points
    Ignition and electrics
    Guideline
  • Inspect frame, welds and lugs for cracks
    Rear suspension and frame
    Guideline

Every 4 years

3 items
  • Replace fuel lines
    Fuel and air
    Factory

    Manual: Fuel pipes. Factory: Replace every 4 years

  • Inspect brake hoses; replace old rubber
    Brakes
    Factory

    Manual: Brake pipes. Factory: Replace every 4 years

  • Rebuild calipers and master cylinders (seals)
    Brakes
    Guideline

Every 6 years

1 item
  • Replace tires on age (regardless of tread)
    Wheels and tires
    Guideline

Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.

Keep up with this schedule on your phone

Add the bike in the app and this chart loads itself, ready to log against and edit.

Coming soon to Google Play

Other 2008 Moto Guzzi models

All 2008 Moto Guzzi