MotoService Log
Yamaha MT-125
Example photo: Cjp24, CC BY-SA 4.0, Wikimedia Commons
Yamaha · Modern air-cooled single (2000-)

MT-125

Library entry covers 2015-2024

29 factory 28 guideline

Published source

Yamaha MT125/MT125A Owner's Manual 5D7-F8199-E4 (English), Periodic maintenance charts pp.6-3 to 6-7

Factory owner's handbook. Covers 2014 (MT125 / MT125A, EU owner's manual 5D7-F8199-E4, printed 2014).

Open the source

57 items for a 2015 model, grouped by interval the way a factory chart is laid out.

How this bike is built (what the schedule is based on)
Engine cycle
Four-stroke
Engine lubrication
Wet sump (oil in crankcase)
Oil filtration
Replaceable cartridge or spin-on filter
Valve gear
Overhead cam, screw/locknut adjusters
Ignition
Electronic (CDI / transistor / ECU)
Charging
Alternator / stator with rectifier
Battery
Wet cell (flooded lead-acid, needs topping up)
Fuel system
Fuel injection
Cooling
Air / oil cooled
Primary drive
Gear or chain inside engine, shares engine oil
Gearbox oil
Shares engine oil
Clutch control
Hand lever, cable
Final drive
Chain
Front suspension
Telescopic fork
Rear suspension
Swingarm, twin shocks
Front brake
Disc, hydraulic
Rear brake
Drum (or band / belt rim)
Wheels
Spoked, tubed
Sidecar
No sidecar
Maintenance schedule

2015 Yamaha MT-125

On the road: every 200 mi

1 item
  • Check engine oil level
    Pre-ride / on the road
    Guideline

    Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.

On the road: every 300 mi

2 items
  • Check lights, horn, brake light switches
    Pre-ride / on the road
    Guideline
  • Check tire pressures
    Pre-ride / on the road
    Guideline

On the road: every 600 mi

2 items
  • Check chain slack and rear wheel alignment
    Pre-ride / on the road
    Guideline
  • Lubricate drive chain
    Pre-ride / on the road
    Factory

    Manual: Drive chain (check slack, alignment; adjust and lubricate). Factory: Every 1000 km (600 mi) and after washing or riding in rain

Every 1,000 mi or 6 months

1 item
  • Adjust rear drum brake and rod / cable linkage
    Brakes
    Guideline

Every 1,800 mi

1 item
  • Change engine oil
    Engine
    Factory

    Manual: Engine oil (change). Factory: Indicator: 1000km(600mi) initial, 2000km later, then every 3000km(1800mi)

Every 3,000 mi or 12 months

4 items
  • Clean drive chain thoroughly (remove and soak, re-lube)
    Final drive
    Guideline

    Non O-ring chains on old machines: remove, clean, soak in hot chain grease or lube, refit with the master link clip closed end leading.

  • Inspect chain and sprockets for wear (measure stretch)
    Final drive
    Guideline
  • Check footrests, pegs, rear brake and gear lever pivots
    Rear suspension and frame
    Guideline
  • Check spoke tension and wheel true
    Wheels and tires
    Guideline

Every 3,500 mi or 12 months

9 items
  • Chassis fasteners (check tightness)
    Engine
    Factory

    Factory: 6000km columns and annual check

  • Inspect coolant hoses and clamps
    Engine
    Factory

    Manual: Cooling system (check coolant level and leakage). Factory: 6000km columns and annual check

  • Check throttle cable(s) free play and return
    Fuel and air
    Factory

    Manual: Throttle grip (check free play, lubricate cable and housing). Factory: 6000km columns and annual check

  • Fuel injection (check engine idle speed)
    Fuel and air
    Factory

    Factory: 6000km columns and annual check

  • Check battery electrolyte, top up with distilled water
    Ignition and electrics
    Factory

    Manual: Battery (check electrolyte level and specific gravity, breather hose). Factory: 6000km columns and annual check

  • Grease and check center / side stand and springs
    Rear suspension and frame
    Factory

    Manual: Sidestand (check operation, lubricate). Factory: 6000km columns and annual check

  • Check brake pads and discs
    Brakes
    Factory

    Manual: Front/rear brake (check operation, fluid level, leakage). Factory: Every column incl. initial; pads replaced whenever worn to limit

  • Inspect tire tread, sidewalls and date codes
    Wheels and tires
    Factory

    Manual: Tires (check tread depth, damage, pressure). Factory: 6000km columns and annual check

  • Lubricate control cables and lever pivots
    Controls and cables
    Factory

    Manual: Moving parts and cables; lever and pedal pivots (lubricate). Factory: 6000km columns and annual check

Every 3,500 mi

8 items
  • Check and adjust valve clearances
    Engine
    Factory

    Manual: Valves (check clearance, adjust). Factory: 6000km(3500mi) columns; from 30000km repeat from 6000km

  • Replace oil filter
    Engine
    Factory

    Manual: Engine oil filter element (replace). Factory: Marked 1000km initial, then every 6000km column

  • Adjust clutch free play, lubricate cable and lever pivot
    Primary and gearbox
    Factory

    Manual: Clutch (check operation, adjust). Factory: Marked 1000km initial, then every 6000km

  • Check steering head bearing adjustment
    Front end
    Factory

    Manual: Steering bearings (check play and roughness). Factory: Marked 1000km initial, then every 6000km

  • Inspect fork seals, stanchions and fork boots
    Front end
    Factory

    Manual: Front fork (check operation and oil leakage). Factory: 6000km columns

  • Check swingarm bushes for play
    Rear suspension and frame
    Factory

    Manual: Swingarm (check operation and excessive play). Factory: 6000km columns

  • Inspect rear shocks for leaks and damping
    Rear suspension and frame
    Factory

    Manual: Shock absorber assembly (check operation and oil leakage). Factory: 6000km columns

  • Check wheel bearings for play
    Wheels and tires
    Factory

    Manual: Wheel bearings (check looseness or damage). Factory: 6000km columns

Every 4,000 mi or 12 months

1 item
  • Lubricate brake cam spindles, check linings and drums
    Brakes
    Guideline

Every 6,000 mi or 12 months

2 items
  • Check charging voltage and regulator / cut-out
    Ignition and electrics
    Guideline
  • Lubricate speedometer / tachometer cables, check drive
    Controls and cables
    Guideline

    A dry speedo cable whips the needle and eventually kills the instrument.

Every 7,000 mi

5 items
  • Inspect, clean and gap spark plugs
    Engine
    Factory

    Manual: Spark plug (check condition, clean, regap). Factory: Marked at 6000km and 18000km; cols 1000/6000/12000/18000/24000km

  • Replace spark plugs
    Engine
    Factory

    Manual: Spark plug (replace). Factory: Marked at 12000km and 24000km

  • Clean / inspect air filter
    Fuel and air
    Factory

    Manual: Air filter element (clean). Factory: Clean at 6000km and 18000km

  • Replace air filter element
    Fuel and air
    Factory

    Manual: Air filter element (replace). Factory: Marked at 12000km and 24000km

  • Clean and grease rear suspension linkage
    Rear suspension and frame
    Factory

    Manual: Rear suspension relay arm and connecting arm pivots (lubricate). Factory: Lubricate at 12000km and 24000km; check every 6000km

Every 10,000 mi or 2 years

1 item
  • Compression test (or leak-down)
    Engine
    Guideline

Every 12,000 mi or 2 years

1 item
  • Synchronize throttle bodies
    Fuel and air
    Guideline

Every 14,000 mi

2 items
  • Repack / replace steering head bearings
    Front end
    Factory

    Manual: Steering bearings (lubricate, lithium-soap grease). Factory: Every 24000 km (14000 mi)

  • Grease swingarm pivot
    Rear suspension and frame
    Factory

    Manual: Swingarm (lubricate, lithium-soap grease). Factory: Every 24000 km (14000 mi)

Every 15,000 mi or 3 years

1 item
  • Change fork oil
    Front end
    Guideline

    Some early telescopic forks are grease filled or use very small oil quantities. Check your manual.

Every 15,000 mi

1 item
  • Replace brake linings / skim drums (wear based)
    Brakes
    Guideline

Every 18,000 mi

1 item
  • Replace chain and sprockets (wear based)
    Final drive
    Guideline

Every 20,000 mi or 4 years

1 item
  • Repack / replace wheel bearings
    Wheels and tires
    Guideline

    Cup-and-cone and taper roller hubs need periodic repacking and adjustment.

Every 24,000 mi or 4 years

1 item
  • Replace fuel filter
    Fuel and air
    Guideline

Every 25,000 mi or 6 years

1 item
  • Replace swingarm bushes / bearings
    Rear suspension and frame
    Guideline

Every 30,000 mi or 6 years

1 item
  • Rebuild forks: seals, bushes, springs
    Front end
    Guideline

Every 6 months

1 item
  • Clean battery terminals, check charge and strap
    Ignition and electrics
    Guideline

Every 2 years

3 items
  • Inspect wiring, bullet connectors and ground points
    Ignition and electrics
    Guideline
  • Inspect frame, welds and lugs for cracks
    Rear suspension and frame
    Guideline
  • Replace brake fluid
    Brakes
    Factory

    Manual: Brake fluid (replace). Factory: Every 2 years

Every 3 years

1 item
  • Replace coolant
    Engine
    Factory

    Manual: Cooling system (change coolant). Factory: Every 3 years

Every 4 years

3 items
  • Replace fuel lines
    Fuel and air
    Guideline

    Old rubber and modern ethanol fuel do not mix well.

  • Inspect brake hoses; replace old rubber
    Brakes
    Factory

    Manual: Brake hoses (replace). Factory: Every 4 years; checked every 6000km and annually

  • Rebuild calipers and master cylinders (seals)
    Brakes
    Guideline

Every 6 years

2 items
  • Replace inner tubes and rim tape with tires
    Wheels and tires
    Guideline
  • Replace tires on age (regardless of tread)
    Wheels and tires
    Guideline

Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.

Keep up with this schedule on your phone

Add the bike in the app and this chart loads itself, ready to log against and edit.

Coming soon to Google Play

Other 2015 Yamaha models

All 2015 Yamaha