MotoService Log
Cleveland Two-stroke / Four
Example photo: Qflieger, CC BY 3.0, Wikimedia Commons

Have this bike? Send a photo or the manual's service chart

Cleveland · Two-stroke twin, premix, chain drive

Two-stroke / Four

Library entry covers 1915-1929

62 guideline

Source

No published schedule found yet

These are general intervals for this bike's era and layout, so check them against your workshop manual.

62 items for a 1915 model, grouped by interval the way a factory chart is laid out.

How this bike is built (what the schedule is based on)
Engine cycle
Two-stroke
Engine lubrication
Two-stroke premix (oil in fuel)
Oil filtration
None (no filter)
Valve gear
None (two-stroke porting)
Ignition
Magneto (incl. magdyno, flywheel magneto)
Charging
None (magneto only / no battery charging)
Battery
Wet cell (flooded lead-acid, needs topping up)
Fuel system
Single carburetor
Cooling
Air / oil cooled
Primary drive
Exposed or dry chain (greased)
Gearbox oil
Separate gearbox oil
Clutch control
Foot clutch / hand shift
Final drive
Chain
Front suspension
Girder fork
Rear suspension
Rigid (hardtail)
Front brake
Drum (or band / stirrup)
Rear brake
Drum (or band / belt rim)
Wheels
Spoked, tubed
Sidecar
No sidecar
Maintenance schedule

1915 Cleveland Two-stroke / Four

On the road: every 200 km

1 item
  • Check two-stroke oil tank / carry premix oil
    Pre-ride / on the road
    Guideline

    Running a two-stroke out of oil seizes it. Injection bikes: check the tank. Premix: carry oil and a measure.

On the road: every 500 km

3 items
  • Acetylene / oil lamps: check carbide, water and wicks
    Pre-ride / on the road
    Guideline
  • Check tire pressures
    Pre-ride / on the road
    Guideline
  • Lubricate drive chain
    Pre-ride / on the road
    Guideline

    Lube warm, ideally at the end of the riding day so it soaks in overnight. Sooner after rain.

On the road: every 800 km

2 items
  • Grease girder / springer fork links
    Pre-ride / on the road
    Guideline

    Grease gun on every nipple until clean grease shows. Touring days add up fast.

  • Walk-around: check nuts and bolts for vibration loosening
    Pre-ride / on the road
    Guideline

    Old machines shake things loose: exhaust nuts, mudguard stays, footrests, tank mounts, battery strap.

On the road: every 1,000 km

1 item
  • Check chain slack and rear wheel alignment
    Pre-ride / on the road
    Guideline

On the road: every 1,600 km

1 item
  • Check road kit: plugs, points file, master link, tube patches, wire, tape
    Pre-ride / on the road
    Guideline

Every 800 km

1 item
  • Clean and grease exposed primary chain
    Primary and gearbox
    Guideline

Every 1,600 km or 6 months

9 items
  • Inspect, clean and gap spark plugs
    Engine
    Guideline
  • Lubricate manual advance / retard control and cable
    Ignition and electrics
    Guideline
  • Adjust foot clutch and hand-shift linkage, lubricate pivots
    Primary and gearbox
    Guideline
  • Check gearbox oil level
    Primary and gearbox
    Guideline
  • Adjust front drum brake
    Brakes
    Guideline
  • Adjust rear drum brake and rod / cable linkage
    Brakes
    Guideline
  • Check spoke tension and wheel true
    Wheels and tires
    Guideline
  • Inspect tire tread, sidewalls and date codes
    Wheels and tires
    Guideline
  • Lubricate control cables and lever pivots
    Controls and cables
    Guideline

Every 1,600 km or 12 months

1 item
  • Grease saddle pivot, check saddle springs / seat post
    Rear suspension and frame
    Guideline

Every 2,500 km or 6 months

2 items
  • Clean / inspect air filter
    Fuel and air
    Guideline

    Mesh or oiled foam: clean and re-oil. Paper: blow out or replace. Some very early machines have no filter at all.

  • Clean drive chain thoroughly (remove and soak, re-lube)
    Final drive
    Guideline

    Non O-ring chains on old machines: remove, clean, soak in hot chain grease or lube, refit with the master link clip closed end leading.

Every 3,000 km or 12 months

4 items
  • Replace spark plugs (two-stroke)
    Engine
    Guideline
  • Change gearbox oil
    Primary and gearbox
    Guideline
  • Check / adjust primary chain
    Primary and gearbox
    Guideline
  • Check girder fork spindle play, adjust friction / hydraulic damper
    Front end
    Guideline

Every 5,000 km or 12 months

13 items
  • Check engine mounting bolts and plates
    Engine
    Guideline
  • Check throttle cable(s) free play and return
    Fuel and air
    Guideline
  • Clean fuel tap filter / sediment bowl
    Fuel and air
    Guideline
  • Check / set ignition timing
    Ignition and electrics
    Guideline
  • Clean and gap contact breaker points, oil cam felt
    Ignition and electrics
    Guideline
  • Adjust clutch pushrod / clutch adjuster
    Primary and gearbox
    Guideline
  • Check chain guard, chain oiler (if fitted), rear chain case
    Final drive
    Guideline
  • Inspect chain and sprockets for wear (measure stretch)
    Final drive
    Guideline
  • Check steering damper (friction or hydraulic)
    Front end
    Guideline
  • Check steering head bearing adjustment
    Front end
    Guideline
  • Check footrests, pegs, rear brake and gear lever pivots
    Rear suspension and frame
    Guideline
  • Grease and check center / side stand and springs
    Rear suspension and frame
    Guideline
  • Check wheel bearings for play
    Wheels and tires
    Guideline

Every 5,000 km or 2 years

1 item
  • Decarbonize exhaust ports, pipes and baffles
    Engine
    Guideline

    Two-strokes coke up the exhaust port and muffler baffles; power falls off gradually.

Every 6,500 km or 12 months

2 items
  • Replace spark plugs
    Engine
    Guideline
  • Lubricate brake cam spindles, check linings and drums
    Brakes
    Guideline

Every 8,000 km or 2 years

1 item
  • Check cylinder head bolt torque
    Engine
    Guideline

    Air-cooled iron and alloy engines can lose head bolt tension; follow your manual's sequence and whether it is done hot or cold.

Every 9,500 km or 12 months

3 items
  • Clean carburetor float bowl(s), check float level and jets
    Fuel and air
    Guideline

    Ethanol fuel varnishes old carbs quickly in storage.

  • Inspect girder fork links, springs and spindles for wear or cracks
    Front end
    Guideline
  • Lubricate speedometer / tachometer cables, check drive
    Controls and cables
    Guideline

    A dry speedo cable whips the needle and eventually kills the instrument.

Every 9,500 km or 2 years

3 items
  • Lubricate and check automatic advance unit
    Ignition and electrics
    Guideline
  • Magneto: clean slip ring and pickup brush, check HT lead
    Ignition and electrics
    Guideline
  • Repack / replace wheel bearings
    Wheels and tires
    Guideline

    Cup-and-cone and taper roller hubs need periodic repacking and adjustment.

Every 16,000 km or 2 years

1 item
  • Compression test (or leak-down)
    Engine
    Guideline

Every 16,000 km or 3 years

1 item
  • Repack / replace steering head bearings
    Front end
    Guideline

    Many old machines use loose balls in cups and cones. Taper roller conversions are common.

Every 16,000 km

1 item
  • Replace chain and sprockets (wear based)
    Final drive
    Guideline

Every 19,500 km or 3 years

1 item
  • Replace points and condenser
    Ignition and electrics
    Guideline

Every 24,000 km or 5 years

1 item
  • Inspect clutch plates and springs
    Primary and gearbox
    Guideline

Every 24,000 km

1 item
  • Replace brake linings / skim drums (wear based)
    Brakes
    Guideline

Every 40,000 km or 10 years

1 item
  • Magneto overhaul / re-magnetize, replace capacitor
    Ignition and electrics
    Guideline

    Weak spark when hot is the classic symptom. Old capacitors fail with age, not miles.

Every 12 months

1 item
  • Check speedometer / odometer against a known distance
    Controls and cables
    Guideline

    Old speedos drift with tire size and drive wear. Use phone GPS over a measured 10 miles / km.

Every 2 years

3 items
  • Inspect fuel tank for rust, sealer failure, leaks
    Fuel and air
    Guideline
  • Inspect wiring, bullet connectors and ground points
    Ignition and electrics
    Guideline
  • Inspect frame, welds and lugs for cracks
    Rear suspension and frame
    Guideline

Every 4 years

1 item
  • Replace fuel lines
    Fuel and air
    Guideline

    Old rubber and modern ethanol fuel do not mix well.

Every 6 years

2 items
  • Replace inner tubes and rim tape with tires
    Wheels and tires
    Guideline
  • Replace tires on age (regardless of tread)
    Wheels and tires
    Guideline

Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.

Keep up with this schedule on your phone

Add the bike in the app and this chart loads itself, ready to log against and edit.

Coming soon to Google Play

Other 1915 Cleveland models

All 1915 Cleveland
1915-1925
Lighweight engine no.286
Guideline