Ducati · Ducati belt-drive desmo (Pantah, SS, Monster, 900-1200 1979-)

Scrambler 800

Library entry covers 2015-2026

11 factory 38 guideline

Published source

Scrambler Ducati MY2016 (USA) owner's manual, Scheduled maintenance chart pp.175-178

Factory owner's handbook. Covers MY2016 Scrambler (USA owner's manual: Icon, Urban Enduro, Full Throttle, Classic).

Open the source

49 items for a 2023 model, grouped by interval the way a factory chart is laid out.

How this bike is built (what the schedule is based on)

Engine cycle: Four-stroke
Engine lubrication: Wet sump (oil in crankcase)
Oil filtration: Replaceable cartridge or spin-on filter
Valve gear: Overhead cam, shim adjusted (incl. desmo)
Ignition: Electronic (CDI / transistor / ECU)
Charging: Alternator / stator with rectifier
Battery: Wet cell (flooded lead-acid, needs topping up)
Fuel system: Single carburetor
Cooling: Air / oil cooled
Primary drive: Gear or chain inside engine, shares engine oil
Gearbox oil: Shares engine oil
Clutch control: Hand lever, hydraulic
Final drive: Chain
Front suspension: Telescopic fork
Rear suspension: Swingarm, single shock / cantilever
Front brake: Disc, hydraulic
Rear brake: Disc, hydraulic
Wheels: Cast / alloy, tubeless
Sidecar: No sidecar

Maintenance schedule

2023 Ducati Scrambler 800

On the road: every 200 mi

1 item

Check engine oil level

Pre-ride / on the road

Guideline

Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.

On the road: every 300 mi

3 items

Check lights, horn, brake light switches

Pre-ride / on the road

Guideline
Check tire pressures

Pre-ride / on the road

Guideline
Lubricate drive chain

Pre-ride / on the road

Guideline

Lube warm, ideally at the end of the riding day so it soaks in overnight. Sooner after rain.

On the road: every 600 mi

1 item

Check chain slack and rear wheel alignment

Pre-ride / on the road

Guideline

Every 1,000 mi or 6 months

1 item

Inspect tire tread, sidewalls and date codes

Wheels and tires

Guideline

Every 3,000 mi or 12 months

6 items

Check throttle cable(s) free play and return

Fuel and air

Guideline
Clean fuel tap filter / sediment bowl

Fuel and air

Guideline
Clean drive chain thoroughly (remove and soak, re-lube)

Final drive

Guideline

Non O-ring chains on old machines: remove, clean, soak in hot chain grease or lube, refit with the master link clip closed end leading.
Inspect fork seals, stanchions and fork boots

Front end

Guideline
Check footrests, pegs, rear brake and gear lever pivots

Rear suspension and frame

Guideline
Grease and check center / side stand and springs

Rear suspension and frame

Guideline

Every 4,000 mi or 12 months

1 item

Inspect, clean and gap spark plugs

Engine

Guideline

Every 6,000 mi or 12 months

7 items

Clean / inspect air filter

Fuel and air

Guideline

Mesh or oiled foam: clean and re-oil. Paper: blow out or replace. Some very early machines have no filter at all.
Clean carburetor float bowl(s), check float level and jets

Fuel and air

Guideline

Ethanol fuel varnishes old carbs quickly in storage.
Check charging voltage and regulator / cut-out

Ignition and electrics

Guideline
Check swingarm bushes for play

Rear suspension and frame

Guideline
Inspect rear shocks for leaks and damping

Rear suspension and frame

Guideline
Lubricate control cables and lever pivots

Controls and cables

Guideline
Lubricate speedometer / tachometer cables, check drive

Controls and cables

Guideline

A dry speedo cable whips the needle and eventually kills the instrument.

Every 7,500 mi or 12 months

4 items

Change engine oil

Engine

Factory

Manual: Change engine oil and filter. Factory: Columns km x1000 1/12/24/36/48 (mi 0.6/7.5/15/22.5/30); first 1,000 km
Replace oil filter

Engine

Factory

Manual: Change engine oil and filter. Factory: Same row as oil
Inspect chain and sprockets for wear (measure stretch)

Final drive

Factory

Manual: Check final drive (chain, front and rear sprocket) and sliding shoe wear.
Check brake pads and discs

Brakes

Factory

Manual: Check brake disk and pad wear. Change if necessary.

Every 7,500 mi

1 item

Check valve clearances (shim adjusted)

Engine

Factory

Manual: Check and/or adjust valve clearance. Factory: Desmodromic

Every 10,000 mi or 2 years

1 item

Compression test (or leak-down)

Engine

Guideline

Every 12,000 mi or 2 years

3 items

Replace cam timing belts

Engine

Guideline

Belt life is age and mileage limited. Newer models allow longer intervals: check yours.
Clean and grease rear suspension linkage

Rear suspension and frame

Guideline
Grease swingarm pivot

Rear suspension and frame

Guideline

Every 15,000 mi or 3 years

1 item

Change fork oil

Front end

Guideline

Some early telescopic forks are grease filled or use very small oil quantities. Check your manual.

Every 15,000 mi or 5 years

1 item

Change timing belts

Ignition and electrics

Factory

Factory: Cam belts; 24,000 km / 15,000 mi or 60 months

Every 15,000 mi

4 items

Replace spark plugs

Engine

Factory

Manual: Change spark plugs.
Replace air filter element

Fuel and air

Factory

Manual: Change air filter.
Check steering head bearing adjustment

Front end

Factory

Manual: Check steering bearings and lubricate, if necessary.
Check wheel bearings for play

Wheels and tires

Factory

Manual: Check wheel hub bearings.

Every 18,000 mi

1 item

Replace chain and sprockets (wear based)

Final drive

Guideline

Every 20,000 mi or 4 years

2 items

Repack / replace steering head bearings

Front end

Guideline

Many old machines use loose balls in cups and cones. Taper roller conversions are common.
Repack / replace wheel bearings

Wheels and tires

Guideline

Cup-and-cone and taper roller hubs need periodic repacking and adjustment.

Every 25,000 mi or 6 years

1 item

Replace swingarm bushes / bearings

Rear suspension and frame

Guideline

Every 30,000 mi or 6 years

1 item

Rebuild forks: seals, bushes, springs

Front end

Guideline

Every 6 months

1 item

Clean battery terminals, check charge and strap

Ignition and electrics

Guideline

Every 2 years

3 items

Inspect wiring, bullet connectors and ground points

Ignition and electrics

Guideline
Replace hydraulic clutch fluid

Primary and gearbox

Guideline
Inspect frame, welds and lugs for cracks

Rear suspension and frame

Guideline

Every 3 years

1 item

Replace brake fluid

Brakes

Factory

Manual: Change brake fluid. Factory: Time only

Every 4 years

3 items

Replace fuel lines

Fuel and air

Guideline

Old rubber and modern ethanol fuel do not mix well.
Inspect brake hoses; replace old rubber

Brakes

Guideline
Rebuild calipers and master cylinders (seals)

Brakes

Guideline

Every 6 years

1 item

Replace tires on age (regardless of tread)

Wheels and tires

Guideline

Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.