
Road Glide (1917 cc)
Library entry covers 1998-2025
Published source
Harley-Davidson 2018 Maintenance Schedules, Table 2-1 Regular Service Intervals: Touring Models
Factory factory bulletin. Covers 2018 Touring models table (Milwaukee-Eight).
Open the source47 items for a 2021 model, grouped by interval the way a factory chart is laid out.
How this bike is built (what the schedule is based on)
- Engine cycle
- Four-stroke
- Engine lubrication
- Dry sump (separate oil tank)
- Oil filtration
- Replaceable cartridge or spin-on filter
- Valve gear
- Hydraulic lifters (no routine clearance adjustment)
- Ignition
- Electronic (CDI / transistor / ECU)
- Charging
- Alternator / stator with rectifier
- Battery
- Wet cell (flooded lead-acid, needs topping up)
- Fuel system
- Fuel injection
- Cooling
- Air / oil cooled
- Primary drive
- Gear or chain inside engine, shares engine oil
- Gearbox oil
- Separate gearbox oil
- Clutch control
- Hand lever, cable
- Final drive
- Toothed belt
- Front suspension
- Telescopic fork
- Rear suspension
- Swingarm, twin shocks
- Front brake
- Disc, hydraulic
- Rear brake
- Disc, hydraulic
- Wheels
- Cast / alloy, tubeless
- Sidecar
- No sidecar
2021 Harley-Davidson Road Glide (1917 cc)
On the road: every 200 mi
1 item-
Check engine oil levelPre-ride / on the roadGuideline
Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.
On the road: every 300 mi
2 items-
Check lights, horn, brake light switchesPre-ride / on the roadGuideline
-
Check tire pressuresPre-ride / on the roadGuideline
Every 3,000 mi or 12 months
5 items-
Check throttle cable(s) free play and returnFuel and airGuideline
-
Check steering head bearing adjustmentFront endGuideline
-
Inspect fork seals, stanchions and fork bootsFront endGuideline
-
Check footrests, pegs, rear brake and gear lever pivotsRear suspension and frameGuideline
-
Check wheel bearings for playWheels and tiresGuideline
Every 4,000 mi or 12 months
2 items-
Inspect, clean and gap spark plugsEngineGuideline
-
Adjust clutch free play, lubricate cable and lever pivotPrimary and gearboxGuideline
Every 5,000 mi or 12 months
4 items-
Change engine oilEngineFactory
Manual: Replace engine oil and filter. Factory: First 1,000 mi/1,600 km, then every 5,000 mi/8,000 km; annually if sooner.
-
Replace oil filterEngineFactory
Manual: Replace engine oil and filter. Factory: Replaced with the oil, every 5,000 mi/8,000 km or annually.
-
Inspect brake hoses; replace old rubberBrakesFactory
Manual: Inspect oil lines and brake system for leaks, contact or abrasion. Factory: Every service column; annually if sooner.
-
Inspect tire tread, sidewalls and date codesWheels and tiresFactory
Manual: Check front/rear tire pressure, inspect tread. Factory: Every service column; annually if sooner.
Every 5,000 mi
5 items-
Inspect coolant hoses and clampsEngineFactory
Manual: Check engine coolant freeze point, inspect for leaks. Factory: Every service column (liquid-cooled heads where fitted).
-
Inspect drive belt, pulleys and tensionFinal driveFactory
Manual: Inspect and adjust drive belt and sprockets. Factory: Every service column.
-
Grease and check center / side stand and springsRear suspension and frameFactory
Manual: Inspect and lubricate jiffy stand. Factory: Every service column.
-
Check brake pads and discsBrakesFactory
Manual: Inspect brake pads and discs for wear. Factory: Every service column, 1,000 mi then every 5,000 mi.
-
Lubricate control cables and lever pivotsControls and cablesFactory
Manual: Check, adjust and lubricate brake and clutch controls. Factory: Every service column.
Every 6,000 mi or 12 months
5 items-
Clean / inspect air filterFuel and airGuideline
Mesh or oiled foam: clean and re-oil. Paper: blow out or replace. Some very early machines have no filter at all.
-
Check charging voltage and regulator / cut-outIgnition and electricsGuideline
-
Check swingarm bushes for playRear suspension and frameGuideline
-
Inspect rear shocks for leaks and dampingRear suspension and frameGuideline
-
Lubricate speedometer / tachometer cables, check driveControls and cablesGuideline
A dry speedo cable whips the needle and eventually kills the instrument.
Every 10,000 mi or 2 years
2 items-
Compression test (or leak-down)EngineGuideline
-
Change gearbox oilPrimary and gearboxGuideline
Every 12,000 mi or 2 years
3 items-
Replace air filter elementFuel and airGuideline
-
Synchronize throttle bodiesFuel and airGuideline
-
Grease swingarm pivotRear suspension and frameGuideline
Every 15,000 mi
1 item-
Check spoke tension and wheel trueWheels and tiresFactory
Manual: Check wheel spoke tightness (if equipped). Factory: At 1,000, 5,000, 20,000 mi then every 15,000 mi (24,000 km).
Every 20,000 mi or 4 years
1 item-
Repack / replace wheel bearingsWheels and tiresGuideline
Cup-and-cone and taper roller hubs need periodic repacking and adjustment.
Every 25,000 mi or 6 years
1 item-
Replace swingarm bushes / bearingsRear suspension and frameGuideline
Every 25,000 mi
1 item-
Repack / replace steering head bearingsFront endFactory
Manual: Inspect, lubricate and adjust steering head bearings. Factory: Disassemble, lubricate, inspect and adjust every 25,000 mi (40,000 km).
Every 30,000 mi or 2 years
1 item-
Replace spark plugsEngineFactory
Factory: Every two years or 30,000 mi (48,000 km), whichever comes first.
Every 30,000 mi
1 item-
Replace coolantEngineFactory
Factory: Every 30,000 mi (48,000 km).
Every 50,000 mi
3 items-
Replace drive belt (wear or damage based)Final driveGuideline
-
Change fork oilFront endFactory
Manual: Rebuild front forks / replace fork oil. Factory: Disassemble, inspect, rebuild forks and replace fork oil every 50,000 mi (80,000 km).
-
Rebuild forks: seals, bushes, springsFront endFactory
Manual: Rebuild front forks. Factory: Every 50,000 mi (80,000 km), with fork oil.
Every 100,000 mi
1 item-
Replace fuel filterFuel and airFactory
Factory: Every 100,000 mi (161,000 km); more often in severe conditions.
Every 12 months
1 item-
Clean battery terminals, check charge and strapIgnition and electricsFactory
Manual: Check battery, terminal torque and clean connections annually. Factory: Annually.
Every 2 years
4 items-
Inspect wiring, bullet connectors and ground pointsIgnition and electricsGuideline
-
Replace hydraulic clutch fluidPrimary and gearboxFactory
Manual: Flush clutch system and replace DOT 4 clutch fluid. Factory: Every two years or sooner if moisture 3% or greater.
-
Inspect frame, welds and lugs for cracksRear suspension and frameGuideline
-
Replace brake fluidBrakesFactory
Manual: Flush brake system and replace DOT 4 hydraulic brake fluid. Factory: Every two years or sooner if moisture content is 3% or greater; moisture checked each service.
Every 4 years
2 items-
Replace fuel linesFuel and airGuideline
Old rubber and modern ethanol fuel do not mix well.
-
Rebuild calipers and master cylinders (seals)BrakesGuideline
Every 6 years
1 item-
Replace tires on age (regardless of tread)Wheels and tiresGuideline
Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.
Keep up with this schedule on your phone
Add the bike in the app and this chart loads itself, ready to log against and edit.
