
CBR 150
Library entry covers 2007-2023
Published source
Honda CBR150R Buku Pedoman Pemilik 2022 (Astra Honda Motor, Indonesia market, Indonesian), Jadwal Perawatan Berkala pp.38-39
Factory owner's handbook. Covers CBR150R; 2022 Astra Honda Motor owner's manual (Buku Pedoman Pemilik); Indonesia market, Indonesian.
Open the source56 items for a 2022 model, grouped by interval the way a factory chart is laid out.
How this bike is built (what the schedule is based on)
- Engine cycle
- Four-stroke
- Engine lubrication
- Wet sump (oil in crankcase)
- Oil filtration
- Replaceable cartridge or spin-on filter
- Valve gear
- Overhead cam, shim adjusted (incl. desmo)
- Ignition
- Electronic (CDI / transistor / ECU)
- Charging
- Alternator / stator with rectifier
- Battery
- Wet cell (flooded lead-acid, needs topping up)
- Fuel system
- Fuel injection
- Cooling
- Liquid cooled
- Primary drive
- Gear or chain inside engine, shares engine oil
- Gearbox oil
- Shares engine oil
- Clutch control
- Hand lever, cable
- Final drive
- Chain
- Front suspension
- Telescopic fork
- Rear suspension
- Swingarm, single shock / cantilever
- Front brake
- Disc, hydraulic
- Rear brake
- Disc, hydraulic
- Wheels
- Cast / alloy, tubeless
- Sidecar
- No sidecar
2022 Honda CBR 150
On the road: every 200 mi
1 item-
Check engine oil levelPre-ride / on the roadGuideline
Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.
On the road: every 300 mi
2 items-
Check lights, horn, brake light switchesPre-ride / on the roadGuideline
-
Check tire pressuresPre-ride / on the roadGuideline
On the road: every 311 mi
2 items-
Check chain slack and rear wheel alignmentPre-ride / on the roadFactory
Manual: Drive chain (inspect). Factory: Every 500 km: inspect and lubricate (square + L); also pre-ride check (Rantai Roda)
-
Lubricate drive chainPre-ride / on the roadFactory
Manual: Drive chain (inspect and lubricate). Factory: Every 500 km: inspect and lubricate (square + L); also pre-ride check (Rantai Roda)
On the road: every 500 mi
1 item-
Check coolant levelPre-ride / on the roadGuideline
Every 3,000 mi or 12 months
5 items-
Clean drive chain thoroughly (remove and soak, re-lube)Final driveGuideline
Non O-ring chains on old machines: remove, clean, soak in hot chain grease or lube, refit with the master link clip closed end leading.
-
Inspect chain and sprockets for wear (measure stretch)Final driveGuideline
-
Inspect fork seals, stanchions and fork bootsFront endGuideline
-
Check footrests, pegs, rear brake and gear lever pivotsRear suspension and frameGuideline
-
Check wheel bearings for playWheels and tiresGuideline
Every 3,728 mi or 6 months
12 items-
Change engine oilEngineFactory
Manual: Engine oil (replace). Factory: Replace at 1000 km/2 months initial, then every 6000 km/6 months; also replace at annual check; level check before riding (Oli Mesin)
-
Engine idle speed (inspect)EngineFactory
Factory: Inspect at 1000 km/2 months, then every 6000 km/6 months; annual check (Putaran Stasioner Mesin); dealer item (wrench: intermediate, AHASS recommended)
-
Headlight aim (inspect)EngineFactory
Factory: Inspect every 6000 km/6 months; annual check (Arah Sinar Lampu Depan)
-
Check throttle cable(s) free play and returnFuel and airFactory
Manual: Throttle operation (inspect). Factory: Inspect every 6000 km/6 months; annual check; also pre-ride check (Cara Kerja Gas Tangan); dealer item (wrench: intermediate, AHASS recommended)
-
Replace fuel linesFuel and airFactory
Manual: Fuel line (inspect). Factory: Inspect every 6000 km/6 months (6000-36000 km); annual check (Saluran Bahan Bakar); dealer item (wrench: intermediate, AHASS recommended); schedule is km/months only (no mile figures printed; columns pair 1/6/12/18/24/30/36 x1000 km with 2/6/12/18/24/30/36 months)
-
Adjust clutch free play, lubricate cable and lever pivotPrimary and gearboxFactory
Manual: Clutch system (inspect). Factory: Inspect at 1000 km/2 months, then every 6000 km/6 months; annual check; also pre-ride check (Sistem Kopling)
-
Grease and check center / side stand and springsRear suspension and frameFactory
Manual: Side stand (inspect). Factory: Inspect every 6000 km/6 months; annual check (Standar Samping)
-
Inspect rear shocks for leaks and dampingRear suspension and frameFactory
Manual: Suspension (inspect). Factory: Inspect every 6000 km/6 months; annual check (Suspensi); dealer item (wrench: intermediate, AHASS recommended)
-
Brake light switch (inspect)BrakesFactory
Factory: Inspect every 6000 km/6 months; annual check (Sakelar Lampu Rem)
-
Brake system (inspect)BrakesFactory
Factory: Inspect at 1000 km/2 months, then every 6000 km/6 months; annual check (Sistem Rem)
-
Check brake pads and discsBrakesFactory
Manual: Brake pads wear (inspect). Factory: Inspect every 6000 km/6 months; annual check; also pre-ride check (Keausan Kampas Rem)
-
Inspect tire tread, sidewalls and date codesWheels and tiresFactory
Manual: Wheels/tires (inspect). Factory: Inspect every 6000 km/6 months; annual check; also pre-ride check (Roda/Ban); dealer item (crossed tools: technical, AHASS)
Every 4,000 mi or 12 months
1 item-
Inspect, clean and gap spark plugsEngineGuideline
Every 5,000 mi or 12 months
1 item-
Replace oil filterEngineGuideline
Every 6,000 mi or 12 months
5 items-
Clean / inspect air filterFuel and airGuideline
Mesh or oiled foam: clean and re-oil. Paper: blow out or replace. Some very early machines have no filter at all.
-
Check charging voltage and regulator / cut-outIgnition and electricsGuideline
-
Check swingarm bushes for playRear suspension and frameGuideline
-
Lubricate control cables and lever pivotsControls and cablesGuideline
-
Lubricate speedometer / tachometer cables, check driveControls and cablesGuideline
A dry speedo cable whips the needle and eventually kills the instrument.
Every 7,456 mi or 12 months
4 items-
Inspect coolant hoses and clampsEngineFactory
Manual: Cooling system (inspect). Factory: Inspect at 12000/24000/36000 km (12/24/36 months); annual check (Sistem Pendingin); dealer item (wrench: intermediate, AHASS recommended)
-
Nuts, bolts, fasteners (inspect)EngineFactory
Factory: Inspect at 1000 km/2 months, then at 12000/24000/36000 km; annual check (Mur, Baut, Pengencang); dealer item (wrench: intermediate, AHASS recommended)
-
Replace spark plugsEngineFactory
Manual: Spark plug (replace). Factory: Inspect at 6000/18000/30000 km, replace at 12000/24000/36000 km (same figures in months) (Busi)
-
Check steering head bearing adjustmentFront endFactory
Manual: Steering head bearings (inspect). Factory: Inspect at 12000/24000/36000 km (12/24/36 months); annual check (Bantalan Kepala Kemudi); dealer item (crossed tools: technical, AHASS)
Every 10,000 mi or 2 years
1 item-
Compression test (or leak-down)EngineGuideline
Every 11,185 mi or 18 months
1 item-
Replace air filter elementFuel and airFactory
Manual: Air cleaner (replace). Factory: Replace at 18000/36000 km (18/36 months); service more often if often ridden in wet or dusty areas (Saringan Udara); dealer item (wrench: intermediate, AHASS recommended)
Every 12,000 mi or 2 years
3 items-
Synchronize throttle bodiesFuel and airGuideline
-
Clean and grease rear suspension linkageRear suspension and frameGuideline
-
Grease swingarm pivotRear suspension and frameGuideline
Every 14,913 mi or 2 years
2 items-
Check and adjust valve clearancesEngineFactory
Manual: Valve clearance (inspect). Factory: Inspect at 24000 km/24 months only (single mark in 1-36k table) (Jarak Renggang Klep); dealer item (wrench: intermediate, AHASS recommended)
-
Replace brake fluidBrakesFactory
Manual: Brake fluid (replace). Factory: Inspect at 6000/12000/18000/30000/36000 km, replace at 24000 km/24 months; annual check; regular replacement every 2 years; also pre-ride check; replacement requires mechanical skill (Minyak rem)
Every 15,000 mi or 3 years
1 item-
Change fork oilFront endGuideline
Some early telescopic forks are grease filled or use very small oil quantities. Check your manual.
Every 15,000 mi or 4 years
1 item-
Check valve clearances (shim adjusted)EngineGuideline
Every 18,000 mi
1 item-
Replace chain and sprockets (wear based)Final driveGuideline
Every 20,000 mi or 4 years
2 items-
Repack / replace steering head bearingsFront endGuideline
Many old machines use loose balls in cups and cones. Taper roller conversions are common.
-
Repack / replace wheel bearingsWheels and tiresGuideline
Cup-and-cone and taper roller hubs need periodic repacking and adjustment.
Every 22,369 mi or 3 years
1 item-
Replace coolantEngineFactory
Manual: Radiator coolant (replace). Factory: Inspect at 12000/24000 km, replace at 36000 km/36 months; annual check; regular replacement every 3 years; also pre-ride check; replacement requires mechanical skill (Cairan Pendingin Radiator)
Every 24,000 mi or 4 years
1 item-
Replace fuel filterFuel and airGuideline
Every 25,000 mi or 6 years
1 item-
Replace swingarm bushes / bearingsRear suspension and frameGuideline
Every 30,000 mi or 6 years
1 item-
Rebuild forks: seals, bushes, springsFront endGuideline
Every 6 months
1 item-
Clean battery terminals, check charge and strapIgnition and electricsGuideline
Every 2 years
2 items-
Inspect wiring, bullet connectors and ground pointsIgnition and electricsGuideline
-
Inspect frame, welds and lugs for cracksRear suspension and frameGuideline
Every 4 years
2 items-
Inspect brake hoses; replace old rubberBrakesGuideline
-
Rebuild calipers and master cylinders (seals)BrakesGuideline
Every 6 years
1 item-
Replace tires on age (regardless of tread)Wheels and tiresGuideline
Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.
Keep up with this schedule on your phone
Add the bike in the app and this chart loads itself, ready to log against and edit.




