No photo of this model in the library yet.

Honda · Modern air-cooled single (2000-)

TMX (150 cc)

Library entry covers 2013-2022

25 factory 38 guideline

Published source

Honda TMX Supremo (GL150) Owner's Manual 2024, 32KYAD300 (English, Philippines market), Maintenance Schedule pp.32-33

Factory owner's handbook. Covers TMX Supremo (GL150); 2024 owner's manual 32KYAD300; Philippines market, English.

Open the source

63 items for a 2016 model, grouped by interval the way a factory chart is laid out.

How this bike is built (what the schedule is based on)

Engine cycle: Four-stroke
Engine lubrication: Wet sump (oil in crankcase)
Oil filtration: Replaceable cartridge or spin-on filter
Valve gear: Overhead cam, screw/locknut adjusters
Ignition: Electronic (CDI / transistor / ECU)
Charging: Alternator / stator with rectifier
Battery: Wet cell (flooded lead-acid, needs topping up)
Fuel system: Single carburetor
Cooling: Air / oil cooled
Primary drive: Gear or chain inside engine, shares engine oil
Gearbox oil: Shares engine oil
Clutch control: Hand lever, cable
Final drive: Chain
Front suspension: Telescopic fork
Rear suspension: Swingarm, twin shocks
Front brake: Disc, hydraulic
Rear brake: Drum (or band / belt rim)
Wheels: Spoked, tubed
Sidecar: No sidecar

Maintenance schedule

2016 Honda TMX (150 cc)

On the road: every 200 mi

1 item

Check engine oil level

Pre-ride / on the road

Guideline

Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.

On the road: every 300 mi

4 items

Check chain slack and rear wheel alignment

Pre-ride / on the road

Factory

Manual: Drive chain (inspect). Factory: Every 500 km (300 mi): inspect and lubricate (I, L); pre-ride check
Check lights, horn, brake light switches

Pre-ride / on the road

Guideline
Check tire pressures

Pre-ride / on the road

Guideline
Lubricate drive chain

Pre-ride / on the road

Factory

Manual: Drive chain (lubricate). Factory: Every 500 km (300 mi): inspect and lubricate (I, L); pre-ride check

Every 1,000 mi or 6 months

1 item

Adjust rear drum brake and rod / cable linkage

Brakes

Guideline

Every 2,500 mi or 12 months

14 items

Change engine oil

Engine

Factory

Manual: Engine oil (replace). Factory: Replace at 1000 km (600 mi) initial, then every 4000 km (2500 mi); annual replace; pre-ride check
Check engine breather and oil return

Engine

Factory

Manual: Crankcase breather (clean). Factory: Clean every 4000 km (2500 mi); annual clean (C in Annual Check column); service more often in rain or at full throttle
Choke operation (inspect)

Engine

Factory

Factory: Inspect every 4000 km; annual check; intermediate (wrench) item
Engine idle speed (inspect)

Engine

Factory

Factory: Inspect at 1000 km (600 mi), then every 4000 km; annual check; intermediate (wrench) item
Headlight aim (inspect)

Engine

Factory

Factory: Inspect every 4000 km; annual check
Check throttle cable(s) free play and return

Fuel and air

Factory

Manual: Throttle operation (inspect). Factory: Inspect every 4000 km; annual check; pre-ride check; intermediate (wrench) item
Replace fuel lines

Fuel and air

Factory

Manual: Fuel line (inspect). Factory: Inspect every 4000 km (2500 mi); annual check; intermediate (wrench) item
Clutch system (inspect)

Primary and gearbox

Factory

Factory: Inspect at 1000 km (600 mi), then every 4000 km; annual check; pre-ride check; no maintenance-level icon on this row
Grease and check center / side stand and springs

Rear suspension and frame

Factory

Manual: Side stand (inspect). Factory: Inspect every 4000 km; annual check
Inspect rear shocks for leaks and damping

Rear suspension and frame

Factory

Manual: Suspension (inspect). Factory: Inspect every 4000 km; annual check; intermediate (wrench) item
Brake system (inspect)

Brakes

Factory

Factory: Inspect at 1000 km (600 mi), then every 4000 km; annual check; pre-ride check. No brake fluid row in this table
Brakelight switch (inspect)

Brakes

Factory

Factory: Inspect every 4000 km; annual check
Check brake pads and discs

Brakes

Factory

Manual: Brake shoes wear (inspect). Factory: Inspect every 4000 km; annual check; pre-ride check
Inspect tire tread, sidewalls and date codes

Wheels and tires

Factory

Manual: Wheels/tires (inspect). Factory: Inspect at 1000 km (600 mi), then every 4000 km; annual check; pre-ride check; technical (crossed tools) dealer item

Every 2,500 mi

2 items

Check and adjust valve clearances

Engine

Factory

Manual: Valve clearance (inspect). Factory: Inspect at 1000 km (600 mi), then every 4000 km (2500 mi); no annual mark; intermediate (wrench) item
Replace fuel filter

Fuel and air

Factory

Manual: Fuel strainer screen (clean). Factory: Clean every 4000 km (2500 mi), 4000-24000 km; no annual mark; intermediate (wrench) item

Every 3,000 mi or 12 months

7 items

Clean fuel tap filter / sediment bowl

Fuel and air

Guideline
Clean drive chain thoroughly (remove and soak, re-lube)

Final drive

Guideline

Non O-ring chains on old machines: remove, clean, soak in hot chain grease or lube, refit with the master link clip closed end leading.
Inspect chain and sprockets for wear (measure stretch)

Final drive

Guideline
Inspect fork seals, stanchions and fork boots

Front end

Guideline
Check footrests, pegs, rear brake and gear lever pivots

Rear suspension and frame

Guideline
Check spoke tension and wheel true

Wheels and tires

Guideline
Check wheel bearings for play

Wheels and tires

Guideline

Every 4,000 mi or 12 months

3 items

Inspect, clean and gap spark plugs

Engine

Guideline
Adjust clutch free play, lubricate cable and lever pivot

Primary and gearbox

Guideline
Lubricate brake cam spindles, check linings and drums

Brakes

Guideline

Every 5,000 mi or 12 months

2 items

Nuts, bolts, fasteners (inspect)

Engine

Factory

Factory: Inspect at 1000 km (600 mi), then 8000/16000/24000 km; annual check; intermediate (wrench) item
Replace oil filter

Engine

Guideline

Every 5,000 mi

1 item

Replace spark plugs

Engine

Factory

Manual: Spark plug (replace). Factory: Inspect at 4000/12000/20000 km, replace at 8000/16000/24000 km (5000/10000/15000 mi)

Every 6,000 mi or 12 months

6 items

Clean / inspect air filter

Fuel and air

Guideline

Mesh or oiled foam: clean and re-oil. Paper: blow out or replace. Some very early machines have no filter at all.
Clean carburetor float bowl(s), check float level and jets

Fuel and air

Guideline

Ethanol fuel varnishes old carbs quickly in storage.
Check charging voltage and regulator / cut-out

Ignition and electrics

Guideline
Check swingarm bushes for play

Rear suspension and frame

Guideline
Lubricate control cables and lever pivots

Controls and cables

Guideline
Lubricate speedometer / tachometer cables, check drive

Controls and cables

Guideline

A dry speedo cable whips the needle and eventually kills the instrument.

Every 7,500 mi or 12 months

2 items

Secondary air supply system (inspect)

Engine

Factory

Factory: Inspect at 12000 and 24000 km (7500/15000 mi); annual check; intermediate (wrench) item
Check steering head bearing adjustment

Front end

Factory

Manual: Steering head bearings (inspect). Factory: Inspect at 1000 km (600 mi), then 12000 and 24000 km; annual check; technical (crossed tools) dealer item

Every 7,500 mi

2 items

Clean oil strainers / mesh screens

Engine

Factory

Manual: Engine oil strainer screen (clean). Factory: Clean at 12000 and 24000 km (7500/15000 mi); technical (crossed tools) dealer item
Engine oil centrifugal filter (clean)

Engine

Factory

Factory: Clean at 12000 and 24000 km (7500/15000 mi); technical (crossed tools) dealer item

Every 10,000 mi or 2 years

1 item

Compression test (or leak-down)

Engine

Guideline

Every 10,000 mi

1 item

Replace air filter element

Fuel and air

Factory

Manual: Air cleaner (replace). Factory: Replace at 16000 km (10000 mi) only mark in the 24000 km table; repeat at that interval per note *1; service more often in unusually wet or dusty areas; intermediate (wrench) item

Every 12,000 mi or 2 years

1 item

Grease swingarm pivot

Rear suspension and frame

Guideline

Every 15,000 mi or 3 years

1 item

Change fork oil

Front end

Guideline

Some early telescopic forks are grease filled or use very small oil quantities. Check your manual.

Every 15,000 mi

1 item

Replace brake linings / skim drums (wear based)

Brakes

Guideline

Every 18,000 mi

1 item

Replace chain and sprockets (wear based)

Final drive

Guideline

Every 20,000 mi or 4 years

2 items

Repack / replace steering head bearings

Front end

Guideline

Many old machines use loose balls in cups and cones. Taper roller conversions are common.
Repack / replace wheel bearings

Wheels and tires

Guideline

Cup-and-cone and taper roller hubs need periodic repacking and adjustment.

Every 25,000 mi or 6 years

1 item

Replace swingarm bushes / bearings

Rear suspension and frame

Guideline

Every 30,000 mi or 6 years

1 item

Rebuild forks: seals, bushes, springs

Front end

Guideline

Every 6 months

1 item

Clean battery terminals, check charge and strap

Ignition and electrics

Guideline

Every 2 years

3 items

Inspect wiring, bullet connectors and ground points

Ignition and electrics

Guideline
Inspect frame, welds and lugs for cracks

Rear suspension and frame

Guideline
Replace brake fluid

Brakes

Guideline

Every 4 years

2 items

Inspect brake hoses; replace old rubber

Brakes

Guideline
Rebuild calipers and master cylinders (seals)

Brakes

Guideline

Every 6 years

2 items

Replace inner tubes and rim tape with tires

Wheels and tires

Guideline
Replace tires on age (regardless of tread)

Wheels and tires

Guideline

Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.