
TR 50
Library entry covers 2016-2021
Source
No published schedule found yet
These are general intervals for this bike's era and layout, so check them against your workshop manual.
51 items for a 2016 model, grouped by interval the way a factory chart is laid out.
How this bike is built (what the schedule is based on)
- Engine cycle
- Two-stroke
- Engine lubrication
- Two-stroke premix (oil in fuel)
- Oil filtration
- None (no filter)
- Valve gear
- None (two-stroke porting)
- Ignition
- Magneto (incl. magdyno, flywheel magneto)
- Charging
- Alternator / stator with rectifier
- Battery
- Wet cell (flooded lead-acid, needs topping up)
- Fuel system
- Single carburetor
- Cooling
- Air / oil cooled
- Primary drive
- Gear or chain inside engine, shares engine oil
- Gearbox oil
- Separate gearbox oil
- Clutch control
- Hand lever, cable
- Final drive
- Chain
- Front suspension
- Telescopic fork
- Rear suspension
- Swingarm, twin shocks
- Front brake
- Drum (or band / stirrup)
- Rear brake
- Disc, hydraulic
- Wheels
- Spoked, tubed
- Sidecar
- No sidecar
2016 KSR TR 50
On the road: every 200 km
1 item-
Check two-stroke oil tank / carry premix oilPre-ride / on the roadGuideline
Running a two-stroke out of oil seizes it. Injection bikes: check the tank. Premix: carry oil and a measure.
On the road: every 500 km
3 items-
Check lights, horn, brake light switchesPre-ride / on the roadGuideline
-
Check tire pressuresPre-ride / on the roadGuideline
-
Lubricate drive chainPre-ride / on the roadGuideline
Lube warm, ideally at the end of the riding day so it soaks in overnight. Sooner after rain.
On the road: every 1,000 km
1 item-
Check chain slack and rear wheel alignmentPre-ride / on the roadGuideline
Every 1,600 km or 6 months
2 items-
Adjust front drum brakeBrakesGuideline
-
Inspect tire tread, sidewalls and date codesWheels and tiresGuideline
Every 3,000 km or 12 months
1 item-
Replace spark plugs (two-stroke)EngineGuideline
Every 5,000 km or 12 months
12 items-
Check throttle cable(s) free play and returnFuel and airGuideline
-
Clean fuel tap filter / sediment bowlFuel and airGuideline
-
Check / set ignition timingIgnition and electricsGuideline
-
Clean and gap contact breaker points, oil cam feltIgnition and electricsGuideline
-
Clean drive chain thoroughly (remove and soak, re-lube)Final driveGuideline
Non O-ring chains on old machines: remove, clean, soak in hot chain grease or lube, refit with the master link clip closed end leading.
-
Inspect chain and sprockets for wear (measure stretch)Final driveGuideline
-
Check steering head bearing adjustmentFront endGuideline
-
Inspect fork seals, stanchions and fork bootsFront endGuideline
-
Check footrests, pegs, rear brake and gear lever pivotsRear suspension and frameGuideline
-
Grease and check center / side stand and springsRear suspension and frameGuideline
-
Check spoke tension and wheel trueWheels and tiresGuideline
-
Check wheel bearings for playWheels and tiresGuideline
Every 5,000 km or 2 years
1 item-
Decarbonize exhaust ports, pipes and bafflesEngineGuideline
Two-strokes coke up the exhaust port and muffler baffles; power falls off gradually.
Every 6,500 km or 12 months
2 items-
Inspect, clean and gap spark plugsEngineGuideline
-
Adjust clutch free play, lubricate cable and lever pivotPrimary and gearboxGuideline
Every 9,500 km or 12 months
7 items-
Clean / inspect air filterFuel and airGuideline
Mesh or oiled foam: clean and re-oil. Paper: blow out or replace. Some very early machines have no filter at all.
-
Clean carburetor float bowl(s), check float level and jetsFuel and airGuideline
Ethanol fuel varnishes old carbs quickly in storage.
-
Check charging voltage and regulator / cut-outIgnition and electricsGuideline
-
Check swingarm bushes for playRear suspension and frameGuideline
-
Inspect rear shocks for leaks and dampingRear suspension and frameGuideline
-
Lubricate control cables and lever pivotsControls and cablesGuideline
-
Lubricate speedometer / tachometer cables, check driveControls and cablesGuideline
A dry speedo cable whips the needle and eventually kills the instrument.
Every 9,500 km or 2 years
2 items-
Lubricate and check automatic advance unitIgnition and electricsGuideline
-
Magneto: clean slip ring and pickup brush, check HT leadIgnition and electricsGuideline
Every 16,000 km or 2 years
2 items-
Compression test (or leak-down)EngineGuideline
-
Change gearbox oilPrimary and gearboxGuideline
Every 19,500 km or 2 years
2 items-
Replace air filter elementFuel and airGuideline
-
Grease swingarm pivotRear suspension and frameGuideline
Every 19,500 km or 3 years
1 item-
Replace points and condenserIgnition and electricsGuideline
Every 24,000 km or 3 years
1 item-
Change fork oilFront endGuideline
Some early telescopic forks are grease filled or use very small oil quantities. Check your manual.
Every 25,500 km or 4 years
1 item-
Replace spark plugsEngineGuideline
Every 29,000 km
1 item-
Replace chain and sprockets (wear based)Final driveGuideline
Every 32,000 km or 4 years
2 items-
Repack / replace steering head bearingsFront endGuideline
Many old machines use loose balls in cups and cones. Taper roller conversions are common.
-
Repack / replace wheel bearingsWheels and tiresGuideline
Cup-and-cone and taper roller hubs need periodic repacking and adjustment.
Every 40,000 km or 6 years
1 item-
Replace swingarm bushes / bearingsRear suspension and frameGuideline
Every 40,000 km or 10 years
1 item-
Magneto overhaul / re-magnetize, replace capacitorIgnition and electricsGuideline
Weak spark when hot is the classic symptom. Old capacitors fail with age, not miles.
Every 48,500 km or 6 years
1 item-
Rebuild forks: seals, bushes, springsFront endGuideline
Every 6 months
1 item-
Clean battery terminals, check charge and strapIgnition and electricsGuideline
Every 2 years
2 items-
Inspect wiring, bullet connectors and ground pointsIgnition and electricsGuideline
-
Inspect frame, welds and lugs for cracksRear suspension and frameGuideline
Every 4 years
1 item-
Replace fuel linesFuel and airGuideline
Old rubber and modern ethanol fuel do not mix well.
Every 6 years
2 items-
Replace inner tubes and rim tape with tiresWheels and tiresGuideline
-
Replace tires on age (regardless of tread)Wheels and tiresGuideline
Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.
Keep up with this schedule on your phone
Add the bike in the app and this chart loads itself, ready to log against and edit.