
Xciting 250
Library entry covers 2006-2008
Published source
Kymco Xciting 500 AFI/500/250 AFI/250 Owner's Manual, issued 15.02.2006, Maintenance Schedule pp.60-65 (factory PDF, copy on archive.org)
Factory owner's handbook. Covers Xciting 250 / 250 AFI, manual issued Feb 2006 (pre-2008).
61 items for a 2006 model, grouped by interval the way a factory chart is laid out.
How this bike is built (what the schedule is based on)
- Engine cycle
- Four-stroke
- Engine lubrication
- Wet sump (oil in crankcase)
- Oil filtration
- Replaceable cartridge or spin-on filter
- Valve gear
- Overhead cam, screw/locknut adjusters
- Ignition
- Electronic (CDI / transistor / ECU)
- Charging
- Alternator / stator with rectifier
- Battery
- Wet cell (flooded lead-acid, needs topping up)
- Fuel system
- Fuel injection
- Cooling
- Liquid cooled
- Primary drive
- Gear or chain inside engine, shares engine oil
- Gearbox oil
- Separate gearbox oil
- Clutch control
- Automatic or semi-automatic
- Final drive
- Belt CVT, scooter automatic
- Front suspension
- Telescopic fork
- Rear suspension
- Swingarm, single shock / cantilever
- Front brake
- Disc, hydraulic
- Rear brake
- Disc, hydraulic
- Wheels
- Cast / alloy, tubeless
- Sidecar
- No sidecar
2006 Kymco Xciting 250
On the road: every 300 km
1 item-
Check engine oil levelPre-ride / on the roadGuideline
Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.
On the road: every 500 km
2 items-
Check lights, horn, brake light switchesPre-ride / on the roadGuideline
-
Check tire pressuresPre-ride / on the roadGuideline
On the road: every 800 km
1 item-
Check coolant levelPre-ride / on the roadGuideline
Every 2,000 km
6 items-
Change engine oilEngineFactory
Manual: Engine oil. Factory: R at 300 km, 1,000 km, then every 2,000 km.
-
Check engine breather and oil returnEngineFactory
Manual: Crankcase breather. Factory: C every column from 1k km.
-
Inspect, clean and gap spark plugsEngineFactory
Manual: Spark plugs. Factory: Note 4: clean every 2,000 km (1,200 mi).
-
Brake systemBrakesFactory
Factory: I every column from 1k km.
-
Check brake pads and discsBrakesFactory
Manual: Brake pad wear. Factory: I every column from 1k km.
-
Inspect tire tread, sidewalls and date codesWheels and tiresFactory
Manual: Wheels/tires. Factory: I every column from 1k km.
Every 4,000 km or 12 months
1 item-
Change final drive (rear drive) oilFinal driveFactory
Manual: Transmission oil. Factory: R at 0.3, 3, 7, 11k; note 5: every 1 year or 4,000 km.
Every 4,000 km
15 items-
Check and adjust valve clearancesEngineFactory
Manual: Valve clearance. Factory: A at 0.3, 3, 7, 11k km.
-
Clean oil strainers / mesh screensEngineFactory
Manual: Engine oil strainer screen. Factory: C at 0.3, 3, 7, 11k km.
-
Engine idle speedEngineFactory
Factory: I at 3, 7, 11k km.
-
Headlight aimEngineFactory
Factory: I at 5, 9k km.
-
Inspect coolant hoses and clampsEngineFactory
Manual: Cooling system. Factory: I at 5, 9k km.
-
Nuts, bolts, fastenersEngineFactory
Factory: I at 0.3, 5, 9k km.
-
Secondary air supply systemEngineFactory
Factory: I at 5, 9k km.
-
SuspensionEngineFactory
Factory: I at 5, 9k km.
-
Check throttle cable(s) free play and returnFuel and airFactory
Manual: Throttle operation. Factory: I at 5, 9k km.
-
Clean / inspect air filterFuel and airFactory
Manual: Air cleaner. Factory: I at 1, 5, 9k km. Cols 0.3/1/3/5/7/9/11 x1000 km; 0.2/0.6/1.8/3/4.2/5.4/6.6 x1000 mi.
-
Replace air filter elementFuel and airFactory
Manual: Air cleaner. Factory: R at 3, 7, 11k km.
-
Replace fuel linesFuel and airFactory
Manual: Fuel line. Factory: I at 5, 9k km.
-
Check steering head bearing adjustmentFront endFactory
Manual: Steering bearings. Factory: I at 0.3, 5, 9k km.
-
Grease and check center / side stand and springsRear suspension and frameFactory
Manual: Side stand. Factory: I at 5, 9k km.
-
Brake light switchBrakesFactory
Factory: I at 5, 9k km.
Every 5,000 km or 12 months
4 items-
Adjust automatic / semi-automatic clutchPrimary and gearboxGuideline
-
Inspect fork seals, stanchions and fork bootsFront endGuideline
-
Check footrests, pegs, rear brake and gear lever pivotsRear suspension and frameGuideline
-
Check wheel bearings for playWheels and tiresGuideline
Every 5,000 km
1 item-
Replace spark plugsEngineFactory
Manual: Spark plugs. Factory: R at 5k; note 4: replace every 5,000 km (3,000 mi).
Every 6,500 km or 12 months
1 item-
Inspect CVT drive belt, rollers / sliders and clutch shoesFinal driveGuideline
Typical scooter interval. Your owner's manual figure governs; check belt width against the service limit.
Every 8,000 km or 12 months
1 item-
Replace oil filterEngineGuideline
Every 9,500 km or 12 months
5 items-
Check charging voltage and regulator / cut-outIgnition and electricsGuideline
-
Check swingarm bushes for playRear suspension and frameGuideline
-
Inspect rear shocks for leaks and dampingRear suspension and frameGuideline
-
Lubricate control cables and lever pivotsControls and cablesGuideline
-
Lubricate speedometer / tachometer cables, check driveControls and cablesGuideline
A dry speedo cable whips the needle and eventually kills the instrument.
Every 10,000 km or 12 months
1 item-
Replace coolantEngineFactory
Manual: Radiator coolant. Factory: R at 5k; note 6: replace every 10,000 km (6,000 mi) or once a year.
Every 16,000 km or 2 years
2 items-
Compression test (or leak-down)EngineGuideline
-
Change gearbox oilPrimary and gearboxGuideline
Every 19,500 km or 2 years
3 items-
Synchronize throttle bodiesFuel and airGuideline
-
Clean and grease rear suspension linkageRear suspension and frameGuideline
-
Grease swingarm pivotRear suspension and frameGuideline
Every 19,500 km or 3 years
1 item-
Replace CVT drive beltFinal driveGuideline
Typical scooter interval, or sooner if the belt is cracked, glazed or below its width limit.
Every 24,000 km or 3 years
1 item-
Change fork oilFront endGuideline
Some early telescopic forks are grease filled or use very small oil quantities. Check your manual.
Every 32,000 km or 4 years
2 items-
Repack / replace steering head bearingsFront endGuideline
Many old machines use loose balls in cups and cones. Taper roller conversions are common.
-
Repack / replace wheel bearingsWheels and tiresGuideline
Cup-and-cone and taper roller hubs need periodic repacking and adjustment.
Every 38,500 km or 4 years
1 item-
Replace fuel filterFuel and airGuideline
Every 40,000 km or 6 years
1 item-
Replace swingarm bushes / bearingsRear suspension and frameGuideline
Every 48,500 km or 6 years
1 item-
Rebuild forks: seals, bushes, springsFront endGuideline
Every 6 months
1 item-
Clean battery terminals, check charge and strapIgnition and electricsGuideline
Every 2 years
4 items-
Inspect wiring, bullet connectors and ground pointsIgnition and electricsGuideline
-
Inspect frame, welds and lugs for cracksRear suspension and frameGuideline
-
BRAKE FLUID (R)BrakesFactory
Factory: As printed: R in the 9 (x1000 km) / 5.4 (x1000 mi) / 24 month column; NOTE 7: Replace every 2 years. Replacement requires mechanical skill.
-
Replace brake fluidBrakesFactory
Manual: Brake fluid. Factory: I at 3, 5, 7, 11k; R at 9k; note 7: replace every 2 years.
Every 4 years
2 items-
Inspect brake hoses; replace old rubberBrakesGuideline
-
Rebuild calipers and master cylinders (seals)BrakesGuideline
Every 6 years
1 item-
Replace tires on age (regardless of tread)Wheels and tiresGuideline
No interval set
2 items-
DRIVE BELTEngineFactory
Factory: As printed: I in the 7 (x1000 km) / 4.2 (x1000 mi) / 18 month column only
-
CLUTCH SHOE WEARPrimary and gearboxFactory
Factory: As printed: I in the 7 (x1000 km) / 4.2 (x1000 mi) / 18 month column only
Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.
Keep up with this schedule on your phone
Add the bike in the app and this chart loads itself, ready to log against and edit.
