
Griso 1100
Library entry covers 2006-2015
Published source
Moto Guzzi Griso V1100 workshop manual UK 8140904, 2.1.2 Scheduled maintenance chart pp.2-5, 2-6
Factory workshop manual. Covers Griso V1100 workshop manual 8140904 (00/2005-11).
Open the source48 items for a 2009 model, grouped by interval the way a factory chart is laid out.
How this bike is built (what the schedule is based on)
- Engine cycle
- Four-stroke
- Engine lubrication
- Wet sump (oil in crankcase)
- Oil filtration
- Replaceable cartridge or spin-on filter
- Valve gear
- Overhead valve, pushrods, adjustable tappets
- Ignition
- Electronic (CDI / transistor / ECU)
- Charging
- Alternator / stator with rectifier
- Battery
- Wet cell (flooded lead-acid, needs topping up)
- Fuel system
- Fuel injection
- Cooling
- Air / oil cooled
- Primary drive
- Gear or chain inside engine, shares engine oil
- Gearbox oil
- Separate gearbox oil
- Clutch control
- Hand lever, cable
- Final drive
- Shaft
- Front suspension
- Telescopic fork
- Rear suspension
- Swingarm, single shock / cantilever
- Front brake
- Disc, hydraulic
- Rear brake
- Disc, hydraulic
- Wheels
- Cast / alloy, tubeless
- Sidecar
- No sidecar
2009 Moto Guzzi Griso 1100
On the road: every 200 mi
1 item-
Check engine oil levelPre-ride / on the roadGuideline
Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.
On the road: every 300 mi
2 items-
Check lights, horn, brake light switchesPre-ride / on the roadGuideline
-
Check tire pressuresPre-ride / on the roadGuideline
Every 1,000 mi or 6 months
1 item-
Inspect tire tread, sidewalls and date codesWheels and tiresGuideline
Every 1,250 mi
1 item-
Check brake pads and discsBrakesFactory
Manual: Brake pads. Factory: Every 2000 km (1250 mi): check; replace if worn
Every 3,000 mi or 12 months
3 items-
Check throttle cable(s) free play and returnFuel and airGuideline
-
Check footrests, pegs, rear brake and gear lever pivotsRear suspension and frameGuideline
-
Grease and check center / side stand and springsRear suspension and frameGuideline
Every 4,000 mi or 12 months
2 items-
Inspect, clean and gap spark plugsEngineGuideline
-
Adjust clutch free play, lubricate cable and lever pivotPrimary and gearboxGuideline
Every 6,000 mi or 12 months
6 items-
Clean / inspect air filterFuel and airGuideline
Mesh or oiled foam: clean and re-oil. Paper: blow out or replace. Some very early machines have no filter at all.
-
Check charging voltage and regulator / cut-outIgnition and electricsGuideline
-
Check final drive for leaks and bearing playFinal driveGuideline
-
Check swingarm bushes for playRear suspension and frameGuideline
-
Inspect rear shocks for leaks and dampingRear suspension and frameGuideline
-
Lubricate speedometer / tachometer cables, check driveControls and cablesGuideline
A dry speedo cable whips the needle and eventually kills the instrument.
Every 6,250 mi or 12 months
11 items-
Change engine oilEngineFactory
Manual: Engine oil. Factory: Replace after running-in 1500 km and every 10000 km / 12 months; 5000 km racing
-
Check and adjust valve clearancesEngineFactory
Manual: Adjusting the valve clearance. Factory: Also after running-in
-
Replace oil filterEngineFactory
Manual: Engine oil filter. Factory: Every 5000 Km (3125 mi) if used for racing
-
Replace spark plugsEngineFactory
Manual: External plugs. Factory: Replace; internal spark plugs adjusted every 20000 km
-
Synchronize throttle bodiesFuel and airFactory
Manual: Cylinder synchronization.
-
Change gearbox oilPrimary and gearboxFactory
Manual: Gearbox fluid. Factory: Replace after running-in
-
Inspect clutch plates and springsPrimary and gearboxFactory
Manual: Clutch wear.
-
Change final drive (rear drive) oilFinal driveFactory
Manual: Final transmission fluid. Factory: Replace after running-in
-
Check steering head bearing adjustmentFront endFactory
Manual: Steering bearings and steering play.
-
Check wheel bearings for playWheels and tiresFactory
Manual: Wheel bearings.
-
Lubricate control cables and lever pivotsControls and cablesFactory
Manual: Transmission and control cables.
Every 10,000 mi or 2 years
1 item-
Compression test (or leak-down)EngineGuideline
Every 12,000 mi or 2 years
2 items-
Clean and grease rear suspension linkageRear suspension and frameGuideline
-
Grease swingarm pivotRear suspension and frameGuideline
Every 12,500 mi or 2 years
1 item-
Replace air filter elementFuel and airFactory
Manual: Air filter. Factory: Check every 10000 km
Every 12,500 mi
3 items-
Check generator drive belt or chainIgnition and electricsFactory
Manual: Generator belt. Factory: Adjust every 20000 km; replace every 50000 km (31250 mi)
-
Change fork oilFront endFactory
Manual: Front fork fluid. Factory: After the first 10000 km (6250 mi), then every 20000 km
-
Inspect fork seals, stanchions and fork bootsFront endFactory
Manual: Fork oil seals. Factory: After the first 30000 km (18750 mi), then every 20000 km
Every 20,000 mi or 4 years
3 items-
Lubricate drive shaft splines / check U-jointFinal driveGuideline
-
Repack / replace steering head bearingsFront endGuideline
Many old machines use loose balls in cups and cones. Taper roller conversions are common.
-
Repack / replace wheel bearingsWheels and tiresGuideline
Cup-and-cone and taper roller hubs need periodic repacking and adjustment.
Every 24,000 mi or 4 years
1 item-
Replace fuel filterFuel and airGuideline
Every 25,000 mi or 6 years
1 item-
Replace swingarm bushes / bearingsRear suspension and frameGuideline
Every 30,000 mi or 6 years
1 item-
Rebuild forks: seals, bushes, springsFront endGuideline
Every 6 months
1 item-
Clean battery terminals, check charge and strapIgnition and electricsGuideline
Every 2 years
3 items-
Inspect wiring, bullet connectors and ground pointsIgnition and electricsGuideline
-
Inspect frame, welds and lugs for cracksRear suspension and frameGuideline
-
Replace brake fluidBrakesFactory
Manual: Brake fluid. Factory: Replace in 20000 km / 24 months column
Every 4 years
3 items-
Replace fuel linesFuel and airFactory
Manual: Fuel hoses. Factory: Every four years: replace
-
Inspect brake hoses; replace old rubberBrakesFactory
Manual: Brake lines. Factory: Every four years: replace
-
Rebuild calipers and master cylinders (seals)BrakesGuideline
Every 6 years
1 item-
Replace tires on age (regardless of tread)Wheels and tiresGuideline
Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.
Keep up with this schedule on your phone
Add the bike in the app and this chart loads itself, ready to log against and edit.

