No photo of this model in the library yet.

Have this bike? Send a photo or the manual's service chart

Suzuki · Overhead-cam four-stroke single, wet sump, gearbox shares engine oil, chain drive

DR-Z 125

Library entry covers 2002-2025

21 factory 36 guideline

Published source

Suzuki DR-Z125/L Service Manual (covers K3-K5 models), Periodic Maintenance Chart p. 2-2

Factory workshop manual. Covers 2003-2005 (DR-Z125/L service manual; chart in months only).

Open the source

57 items for a 2025 model, grouped by interval the way a factory chart is laid out.

How this bike is built (what the schedule is based on)

Engine cycle: Four-stroke
Engine lubrication: Wet sump (oil in crankcase)
Oil filtration: Replaceable cartridge or spin-on filter
Valve gear: Overhead cam, screw/locknut adjusters
Ignition: Electronic (CDI / transistor / ECU)
Charging: Alternator / stator with rectifier
Battery: Wet cell (flooded lead-acid, needs topping up)
Fuel system: Single carburetor
Cooling: Air / oil cooled
Primary drive: Gear or chain inside engine, shares engine oil
Gearbox oil: Shares engine oil
Clutch control: Hand lever, cable
Final drive: Chain
Front suspension: Telescopic fork
Rear suspension: Swingarm, single shock / cantilever
Front brake: Drum (or band / stirrup)
Rear brake: Drum (or band / belt rim)
Wheels: Spoked, tubed
Sidecar: No sidecar

Maintenance schedule

2025 Suzuki DR-Z 125

On the road: every 200 mi

1 item

Check engine oil level

Pre-ride / on the road

Guideline

Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.

On the road: every 300 mi

3 items

Check lights, horn, brake light switches

Pre-ride / on the road

Guideline
Check tire pressures

Pre-ride / on the road

Guideline
Lubricate drive chain

Pre-ride / on the road

Guideline

Lube warm, ideally at the end of the riding day so it soaks in overnight. Sooner after rain.

On the road: every 600 mi

1 item

Check chain slack and rear wheel alignment

Pre-ride / on the road

Guideline

Every 1,000 mi or 6 months

2 items

Adjust front drum brake

Brakes

Guideline
Adjust rear drum brake and rod / cable linkage

Brakes

Guideline

Every 3,000 mi or 12 months

7 items

Clean fuel tap filter / sediment bowl

Fuel and air

Guideline
Clean drive chain thoroughly (remove and soak, re-lube)

Final drive

Guideline

Non O-ring chains on old machines: remove, clean, soak in hot chain grease or lube, refit with the master link clip closed end leading.
Inspect chain and sprockets for wear (measure stretch)

Final drive

Guideline
Check footrests, pegs, rear brake and gear lever pivots

Rear suspension and frame

Guideline
Grease and check center / side stand and springs

Rear suspension and frame

Guideline
Check spoke tension and wheel true

Wheels and tires

Guideline
Check wheel bearings for play

Wheels and tires

Guideline

Every 4,000 mi or 12 months

1 item

Lubricate brake cam spindles, check linings and drums

Brakes

Guideline

Every 6,000 mi or 12 months

5 items

Clean carburetor float bowl(s), check float level and jets

Fuel and air

Guideline

Ethanol fuel varnishes old carbs quickly in storage.
Check charging voltage and regulator / cut-out

Ignition and electrics

Guideline
Check swingarm bushes for play

Rear suspension and frame

Guideline
Lubricate control cables and lever pivots

Controls and cables

Guideline
Lubricate speedometer / tachometer cables, check drive

Controls and cables

Guideline

A dry speedo cable whips the needle and eventually kills the instrument.

Every 10,000 mi or 2 years

1 item

Compression test (or leak-down)

Engine

Guideline

Every 12,000 mi or 2 years

3 items

Replace air filter element

Fuel and air

Guideline
Clean and grease rear suspension linkage

Rear suspension and frame

Guideline
Grease swingarm pivot

Rear suspension and frame

Guideline

Every 15,000 mi or 3 years

1 item

Change fork oil

Front end

Guideline

Some early telescopic forks are grease filled or use very small oil quantities. Check your manual.

Every 15,000 mi

1 item

Replace brake linings / skim drums (wear based)

Brakes

Guideline

Every 18,000 mi

1 item

Replace chain and sprockets (wear based)

Final drive

Guideline

Every 20,000 mi or 4 years

2 items

Repack / replace steering head bearings

Front end

Guideline

Many old machines use loose balls in cups and cones. Taper roller conversions are common.
Repack / replace wheel bearings

Wheels and tires

Guideline

Cup-and-cone and taper roller hubs need periodic repacking and adjustment.

Every 25,000 mi or 6 years

1 item

Replace swingarm bushes / bearings

Rear suspension and frame

Guideline

Every 30,000 mi or 6 years

1 item

Rebuild forks: seals, bushes, springs

Front end

Guideline

Every 6 months

13 items

Change engine oil

Engine

Factory

Manual: Engine oil - R. Factory: Initially 1 month; then every 6 months
Chassis nuts and bolts - T

Engine

Factory

Factory: Tighten initially 1 month; then every 6 months
Check and adjust valve clearances

Engine

Factory

Manual: Valve clearance - I. Factory: Initially 1 month; then every 6 months
Exhaust pipe bolts and muffler mounting bolts - T

Engine

Factory

Factory: Tighten initially 1 month, then every 6 months
Idle speed - I

Engine

Factory

Factory: Initially 1 month; then every 6 months
Inspect, clean and gap spark plugs

Engine

Factory

Manual: Spark plug - I. Factory: Inspected in 6-month column
Check throttle cable(s) free play and return

Fuel and air

Factory

Manual: Throttle cable - I. Factory: Initially 1 month; then every 6 months
Clean / inspect air filter

Fuel and air

Factory

Manual: Air cleaner element - I. Factory: Columns: initially 1 month, every 6 months, every 12 months
Clean battery terminals, check charge and strap

Ignition and electrics

Guideline
Adjust clutch free play, lubricate cable and lever pivot

Primary and gearbox

Factory

Manual: Clutch - I. Factory: Initially 1 month; then every 6 months
Cam chain tension adjuster - I

Final drive

Factory

Factory: Initially 1 month; then every 6 months
Check brake pads and discs

Brakes

Factory

Manual: Brakes - I. Factory: Initially 1 month; then every 6 months
Inspect tire tread, sidewalls and date codes

Wheels and tires

Factory

Manual: Tires - I. Factory: Every 6 months

Every 12 months

6 items

Replace oil filter

Engine

Factory

Manual: Engine oil filter - R. Factory: Initially 1 month; then every 12 months
Replace spark plugs

Engine

Factory

Manual: Spark plug - R. Factory: Replaced in 12-month column
Spark arrester - C

Engine

Factory

Factory: Clean in 12-month column
Check steering head bearing adjustment

Front end

Factory

Manual: Steering - I. Factory: Initially 1 month; then every 12 months
Inspect fork seals, stanchions and fork boots

Front end

Factory

Manual: Front forks - I. Factory: Every 12 months
Inspect rear shocks for leaks and damping

Rear suspension and frame

Factory

Manual: Rear suspension - I. Factory: Every 12 months

Every 2 years

3 items

Inspect wiring, bullet connectors and ground points

Ignition and electrics

Guideline
Inspect frame, welds and lugs for cracks

Rear suspension and frame

Guideline
Replace brake fluid

Brakes

Factory

Manual: Brake fluid - replace every 2 years. Factory: Inspect every 6 months; replace every 2 years

Every 4 years

2 items

Replace fuel lines

Fuel and air

Factory

Manual: Fuel line - I; replace every 4 years. Factory: Inspected initially, 6 and 12 months; replaced every 4 years
Inspect brake hoses; replace old rubber

Brakes

Factory

Manual: Brake hose - I; replace every 4 years. Factory: Inspect every 6 months; replace every 4 years

Every 6 years

2 items

Replace inner tubes and rim tape with tires

Wheels and tires

Guideline
Replace tires on age (regardless of tread)

Wheels and tires

Guideline

Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.