MotoService Log
No photo of this model in the library yet.
Suzuki · Modern air-cooled single (2000-)

V-Strom 250

Library entry covers 2017-2023

28 factory 30 guideline

Published source

Haojue Suzuki DL250 (V-Strom 250) factory service manual (Chinese), periodic maintenance table 定期保养表 p. 2B-2

Factory workshop manual. Covers 2017- (Haojue-Suzuki DL250 China-market service manual; km, miles, months).

Open the source

58 items for a 2023 model, grouped by interval the way a factory chart is laid out.

How this bike is built (what the schedule is based on)
Engine cycle
Four-stroke
Engine lubrication
Wet sump (oil in crankcase)
Oil filtration
Replaceable cartridge or spin-on filter
Valve gear
Overhead cam, screw/locknut adjusters
Ignition
Electronic (CDI / transistor / ECU)
Charging
Alternator / stator with rectifier
Battery
Wet cell (flooded lead-acid, needs topping up)
Fuel system
Fuel injection
Cooling
Air / oil cooled
Primary drive
Gear or chain inside engine, shares engine oil
Gearbox oil
Shares engine oil
Clutch control
Hand lever, cable
Final drive
Chain
Front suspension
Telescopic fork
Rear suspension
Swingarm, twin shocks
Front brake
Disc, hydraulic
Rear brake
Drum (or band / belt rim)
Wheels
Spoked, tubed
Sidecar
No sidecar
Maintenance schedule

2023 Suzuki V-Strom 250

On the road: every 200 mi

1 item
  • Check engine oil level
    Pre-ride / on the road
    Guideline

    Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.

On the road: every 300 mi

2 items
  • Check lights, horn, brake light switches
    Pre-ride / on the road
    Guideline
  • Check tire pressures
    Pre-ride / on the road
    Guideline

On the road: every 621 mi

1 item
  • Lubricate drive chain
    Pre-ride / on the road
    Factory

    Manual: 驱动链条 (drive chain) - inspect, clean, oil. Factory: Every 1 000 km inspect, clean and lubricate (每1 000公里)

On the road: every 3,000 mi or 12 months

1 item
  • Check chain slack and rear wheel alignment
    Pre-ride / on the road
    Factory

    Manual: 驱动链条 (drive chain) - C. Factory: Initial 1 000 km; then every column

Every 621 mi

1 item
  • Lubricate control cables and lever pivots
    Controls and cables
    Factory

    Manual: 润滑点 (lubrication points). Factory: Lubricate every 1 000 km

Every 1,000 mi or 6 months

1 item
  • Adjust rear drum brake and rod / cable linkage
    Brakes
    Guideline

Every 3,000 mi or 12 months

17 items
  • Change engine oil
    Engine
    Factory

    Manual: 发动机机油 (engine oil) - R. Factory: Initial 1 000 km/600 mi/2 months; columns 1 000/5 000/10 000/15 000 km

  • Check and adjust valve clearances
    Engine
    Factory

    Manual: 气门间隙 (valve clearance) - C. Factory: Initial 1 000 km; then every column

  • Inspect coolant hoses and clamps
    Engine
    Factory

    Manual: 散热器软管 (radiator hose) - C. Factory: Every column from 5 000 km

  • Inspect, clean and gap spark plugs
    Engine
    Factory

    Manual: 火花塞 (spark plug) - C. Factory: Inspected at 5 000 and 15 000 km

  • 怠速 (idle speed) - C
    Engine
    Factory

    Factory: Initial 1 000 km; then every column

  • 车体螺栓和螺母 (chassis bolts and nuts) - T
    Engine
    Factory

    Factory: Tighten initially, then every column

  • Check throttle cable(s) free play and return
    Fuel and air
    Factory

    Manual: 油门拉索 (throttle cable) - C. Factory: Initial 1 000 km; then every column

  • Clean / inspect air filter
    Fuel and air
    Factory

    Manual: 空气滤清器滤芯 (air cleaner element) - C. Factory: Inspect/clean at 5 000 and 10 000 km

  • Adjust clutch free play, lubricate cable and lever pivot
    Primary and gearbox
    Factory

    Manual: 离合器拉索间隙 (clutch cable play) - C. Factory: Every column from 5 000 km

  • Clean drive chain thoroughly (remove and soak, re-lube)
    Final drive
    Guideline

    Non O-ring chains on old machines: remove, clean, soak in hot chain grease or lube, refit with the master link clip closed end leading.

  • Inspect chain and sprockets for wear (measure stretch)
    Final drive
    Guideline
  • Check footrests, pegs, rear brake and gear lever pivots
    Rear suspension and frame
    Guideline
  • Grease and check center / side stand and springs
    Rear suspension and frame
    Guideline
  • Check brake pads and discs
    Brakes
    Factory

    Manual: 制动器 (brakes) - C. Factory: Initial 1 000 km; then every column

  • Check spoke tension and wheel true
    Wheels and tires
    Guideline
  • Check wheel bearings for play
    Wheels and tires
    Guideline
  • Inspect tire tread, sidewalls and date codes
    Wheels and tires
    Factory

    Manual: 轮胎 (tires) - C. Factory: Every column from 5 000 km

Every 3,000 mi or 2 years

1 item
  • Replace brake fluid
    Brakes
    Factory

    Manual: 制动液 (brake fluid) - C; replace every 2 years. Factory: Inspect every column from 5 000 km; replace every 2 years

Every 3,000 mi or 4 years

2 items
  • Replace fuel lines
    Fuel and air
    Factory

    Manual: 燃油管 (fuel hose) - C; replace every 4 years. Factory: Inspect every column from 5 000 km; replace every 4 years (每4年更换)

  • Inspect brake hoses; replace old rubber
    Brakes
    Factory

    Manual: 制动软管 (brake hose) - C; replace every 4 years. Factory: Inspect every column from 5 000 km; replace every 4 years

Every 4,000 mi or 12 months

1 item
  • Lubricate brake cam spindles, check linings and drums
    Brakes
    Guideline

Every 6,000 mi or 12 months

3 items
  • Check charging voltage and regulator / cut-out
    Ignition and electrics
    Guideline
  • Check swingarm bushes for play
    Rear suspension and frame
    Guideline
  • Lubricate speedometer / tachometer cables, check drive
    Controls and cables
    Guideline

    A dry speedo cable whips the needle and eventually kills the instrument.

Every 6,000 mi or 2 years

9 items
  • Replace oil filter
    Engine
    Factory

    Manual: 机油滤芯 (oil filter) - R. Factory: Initial 1 000 km; then 10 000 km column

  • Replace spark plugs
    Engine
    Factory

    Manual: 火花塞 (spark plug) - R. Factory: Replaced at 10 000 km column

  • 二次空气系统 (PAIR system) - C
    Engine
    Factory

    Factory: Marked at 5 000 and 15 000 km columns

  • 排气管螺栓和消声器螺栓 (exhaust pipe and muffler bolts) - T
    Engine
    Factory

    Factory: Tighten at 1 000 and 10 000 km

  • Synchronize throttle bodies
    Fuel and air
    Factory

    Manual: 节气门体同步 (throttle body synchronization) - C. Factory: Marked only at 10 000 km column

  • Check steering head bearing adjustment
    Front end
    Factory

    Manual: 转向系统 (steering) - C. Factory: Initial 1 000 km; then 10 000 km column

  • Inspect fork seals, stanchions and fork boots
    Front end
    Factory

    Manual: 前减震器 (front fork) - C. Factory: Marked only at 10 000 km column

  • Inspect rear shocks for leaks and damping
    Rear suspension and frame
    Factory

    Manual: 后悬挂 (rear suspension) - C. Factory: Marked only at 10 000 km column

  • 燃油蒸发控制系统 (evaporative emission control) - C
    Controls and cables
    Factory

    Factory: Marked only at 10 000 km column

Every 9,000 mi or 3 years

1 item
  • Replace air filter element
    Fuel and air
    Factory

    Manual: 空气滤清器滤芯 (air cleaner element) - R. Factory: Replaced at 15 000 km (9 000 mi) column

Every 10,000 mi or 2 years

1 item
  • Compression test (or leak-down)
    Engine
    Guideline

Every 12,000 mi or 2 years

1 item
  • Grease swingarm pivot
    Rear suspension and frame
    Guideline

Every 12,427 mi or 4 years

1 item
  • Replace coolant
    Engine
    Factory

    Manual: 发动机冷却液 Suzuki Super Long Life Coolant (blue) - replace. Factory: Every 4 years or 20 000 km; Long Life coolant: R at 10 000 km/24 months

Every 15,000 mi or 3 years

1 item
  • Change fork oil
    Front end
    Guideline

    Some early telescopic forks are grease filled or use very small oil quantities. Check your manual.

Every 15,000 mi

1 item
  • Replace brake linings / skim drums (wear based)
    Brakes
    Guideline

Every 18,000 mi

1 item
  • Replace chain and sprockets (wear based)
    Final drive
    Guideline

Every 20,000 mi or 4 years

2 items
  • Repack / replace steering head bearings
    Front end
    Guideline

    Many old machines use loose balls in cups and cones. Taper roller conversions are common.

  • Repack / replace wheel bearings
    Wheels and tires
    Guideline

    Cup-and-cone and taper roller hubs need periodic repacking and adjustment.

Every 24,000 mi or 4 years

1 item
  • Replace fuel filter
    Fuel and air
    Guideline

Every 25,000 mi or 6 years

1 item
  • Replace swingarm bushes / bearings
    Rear suspension and frame
    Guideline

Every 30,000 mi or 6 years

1 item
  • Rebuild forks: seals, bushes, springs
    Front end
    Guideline

Every 6 months

1 item
  • Clean battery terminals, check charge and strap
    Ignition and electrics
    Guideline

Every 2 years

2 items
  • Inspect wiring, bullet connectors and ground points
    Ignition and electrics
    Guideline
  • Inspect frame, welds and lugs for cracks
    Rear suspension and frame
    Guideline

Every 4 years

1 item
  • Rebuild calipers and master cylinders (seals)
    Brakes
    Guideline

Every 6 years

2 items
  • Replace inner tubes and rim tape with tires
    Wheels and tires
    Guideline
  • Replace tires on age (regardless of tread)
    Wheels and tires
    Guideline

Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.

Keep up with this schedule on your phone

Add the bike in the app and this chart loads itself, ready to log against and edit.

Coming soon to Google Play

Other 2023 Suzuki models

All 2023 Suzuki