No photo of this model in the library yet.

Have this bike? Send a photo or the manual's service chart

Yamaha · Overhead-cam four-stroke single, wet sump, separate gearbox oil, CVT belt drive

X-Max 300

Library entry covers 2017-2024

31 factory 27 guideline

Published source

Yamaha CZD300-A (X-MAX 300) Owner's Manual B74-F8199-E0 (English), Periodic maintenance charts pp.7-3 to 7-6

Factory owner's handbook. Covers 2017 (CZD300-A X-MAX 300, EU owner's manual B74-F8199-E0, printed May 2017).

Open the source

58 items for a 2024 model, grouped by interval the way a factory chart is laid out.

How this bike is built (what the schedule is based on)

Engine cycle: Four-stroke
Engine lubrication: Wet sump (oil in crankcase)
Oil filtration: Replaceable cartridge or spin-on filter
Valve gear: Overhead cam, screw/locknut adjusters
Ignition: Electronic (CDI / transistor / ECU)
Charging: Alternator / stator with rectifier
Battery: Wet cell (flooded lead-acid, needs topping up)
Fuel system: Fuel injection
Cooling: Liquid cooled
Primary drive: Gear or chain inside engine, shares engine oil
Gearbox oil: Separate gearbox oil
Clutch control: Automatic or semi-automatic
Final drive: Belt CVT, scooter automatic
Front suspension: Telescopic fork
Rear suspension: Swingarm, twin shocks
Front brake: Disc, hydraulic
Rear brake: Disc, hydraulic
Wheels: Spoked, tubed
Sidecar: No sidecar

Maintenance schedule

2024 Yamaha X-Max 300

On the road: every 200 mi

1 item

Check engine oil level

Pre-ride / on the road

Guideline

Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.

On the road: every 300 mi

2 items

Check lights, horn, brake light switches

Pre-ride / on the road

Guideline
Check tire pressures

Pre-ride / on the road

Guideline

On the road: every 500 mi

1 item

Check coolant level

Pre-ride / on the road

Guideline

Every 3,000 mi or 12 months

3 items

Adjust automatic / semi-automatic clutch

Primary and gearbox

Guideline
Check footrests, pegs, rear brake and gear lever pivots

Rear suspension and frame

Guideline
Check spoke tension and wheel true

Wheels and tires

Guideline

Every 3,000 mi

1 item

Change engine oil

Engine

Factory

Manual: Engine oil (change, warm engine before draining). Factory: Initial interval, then when oil change indicator flashes, every 5000km (3000mi)

Every 4,000 mi or 12 months

1 item

Inspect CVT drive belt, rollers / sliders and clutch shoes

Final drive

Guideline

Typical scooter interval. Your owner's manual figure governs; check belt width against the service limit.

Every 6,000 mi or 12 months

13 items

Chassis fasteners (check tightness)

Engine

Factory

Factory: 10000km columns and annual check
Diagnostic system check (Yamaha diagnostic tool, error codes)

Engine

Factory

Factory: Every column incl. initial and annual check
Inspect coolant hoses and clamps

Engine

Factory

Manual: Cooling system (check coolant level and leakage). Factory: 10000km columns and annual check
Check throttle cable(s) free play and return

Fuel and air

Factory

Manual: Throttle grip housing and cable (check free play, lubricate). Factory: 10000km columns and annual check
Fuel injection (check engine idle speed)

Fuel and air

Factory

Factory: Every column incl. 1000km initial and annual check
V-belt case air filter element (clean, replace if necessary)

Fuel and air

Factory

Factory: 10000km columns and annual check
Check charging voltage and regulator / cut-out

Ignition and electrics

Guideline
Check swingarm bushes for play

Rear suspension and frame

Guideline
Grease and check center / side stand and springs

Rear suspension and frame

Factory

Manual: Sidestand, centerstand (check operation, lubricate). Factory: 10000km columns and annual check
Check brake pads and discs

Brakes

Factory

Manual: Front/rear brake (check operation, fluid level, leakage; pads). Factory: Every column incl. initial and annual check
Inspect tire tread, sidewalls and date codes

Wheels and tires

Factory

Manual: Tires (check tread depth, damage, pressure). Factory: 10000km columns and annual check
Lubricate control cables and lever pivots

Controls and cables

Factory

Manual: Moving parts and cables; brake lever pivots (lubricate). Factory: 10000km columns and annual check
Lubricate speedometer / tachometer cables, check drive

Controls and cables

Guideline

A dry speedo cable whips the needle and eventually kills the instrument.

Every 6,000 mi

6 items

Exhaust system (check for leakage, tighten, replace gasket)

Engine

Factory

Factory: Marked 1000km initial, then every 10000km
Air filter case check hose (clean)

Fuel and air

Factory

Factory: Marked 1000km initial, then every 10000km
Check final drive for leaks and bearing play

Final drive

Factory

Manual: Final transmission oil (check vehicle for oil leakage). Factory: Marked 1000km initial, then every 10000km
Inspect fork seals, stanchions and fork boots

Front end

Factory

Manual: Front fork (check operation and oil leakage). Factory: 10000km columns
Inspect rear shocks for leaks and damping

Rear suspension and frame

Factory

Manual: Shock absorber assemblies (check operation and oil leakage). Factory: 10000km columns
Check wheel bearings for play

Wheels and tires

Factory

Manual: Wheel bearings (check looseness or damage). Factory: 10000km columns

Every 10,000 mi or 2 years

2 items

Compression test (or leak-down)

Engine

Guideline
Change gearbox oil

Primary and gearbox

Guideline

Every 12,000 mi or 2 years

2 items

Synchronize throttle bodies

Fuel and air

Guideline
Grease swingarm pivot

Rear suspension and frame

Guideline

Every 12,000 mi or 3 years

1 item

Replace CVT drive belt

Final drive

Guideline

Typical scooter interval, or sooner if the belt is cracked, glazed or below its width limit.

Every 12,000 mi

10 items

Check and adjust valve clearances

Engine

Factory

Manual: Valve clearance (check and adjust). Factory: Every 20000 km (12000 mi)
Inspect, clean and gap spark plugs

Engine

Factory

Manual: Spark plug (check condition, adjust gap and clean). Factory: Marked at 10000km and 30000km; cols 1/10/20/30/40 x1000km
Replace oil filter

Engine

Factory

Manual: Engine oil filter element (replace). Factory: Marked 1000km initial, 20000km, 40000km
Replace spark plugs

Engine

Factory

Manual: Spark plug (replace). Factory: Marked at 20000km and 40000km
Clean / inspect air filter

Fuel and air

Factory

Manual: Pre air filter element (clean). Factory: Marked at 20000km and 40000km
Replace air filter element

Fuel and air

Factory

Manual: Air filter element and sub air filter element (replace). Factory: Marked at 20000km and 40000km
Change final drive (rear drive) oil

Final drive

Factory

Manual: Final transmission oil (change). Factory: Marked 1000km initial, 20000km, 40000km
Replace drive belt (wear or damage based)

Final drive

Factory

Manual: V-belt (replace). Factory: When V-belt replacement indicator flashes, every 20000km (12000mi)
Check steering head bearing adjustment

Front end

Factory

Manual: Steering bearings (check bearing assemblies for looseness). Factory: Marked 1000km, 10000km, 30000km
Repack / replace steering head bearings

Front end

Factory

Manual: Steering bearings (moderately repack, lithium-soap grease). Factory: Marked at 20000km and 40000km

Every 15,000 mi or 3 years

1 item

Change fork oil

Front end

Guideline

Some early telescopic forks are grease filled or use very small oil quantities. Check your manual.

Every 20,000 mi or 4 years

1 item

Repack / replace wheel bearings

Wheels and tires

Guideline

Cup-and-cone and taper roller hubs need periodic repacking and adjustment.

Every 24,000 mi or 4 years

1 item

Replace fuel filter

Fuel and air

Guideline

Every 25,000 mi or 6 years

1 item

Replace swingarm bushes / bearings

Rear suspension and frame

Guideline

Every 30,000 mi or 6 years

1 item

Rebuild forks: seals, bushes, springs

Front end

Guideline

Every 6 months

1 item

Clean battery terminals, check charge and strap

Ignition and electrics

Guideline

Every 2 years

4 items

Inspect wiring, bullet connectors and ground points

Ignition and electrics

Guideline
Inspect frame, welds and lugs for cracks

Rear suspension and frame

Guideline
Rebuild calipers and master cylinders (seals)

Brakes

Factory

Manual: Brake master cylinder and caliper internal components (replace). Factory: Every two years (TIP under chart)
Replace brake fluid

Brakes

Factory

Manual: Brake fluid (change). Factory: Every 2 years

Every 3 years

1 item

Replace coolant

Engine

Factory

Manual: Cooling system (change coolant). Factory: Every 3 years

Every 4 years

2 items

Replace fuel lines

Fuel and air

Guideline

Old rubber and modern ethanol fuel do not mix well.
Inspect brake hoses; replace old rubber

Brakes

Factory

Manual: Brake hoses (replace). Factory: Every 4 years; checked every 10000km and annually

Every 6 years

2 items

Replace inner tubes and rim tape with tires

Wheels and tires

Guideline
Replace tires on age (regardless of tread)

Wheels and tires

Guideline

Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.