No photo of this model in the library yet.

Yamaha · Shim-adjusted overhead-cam four-stroke, wet sump, gearbox shares engine oil, chain drive

XJR 1300

Library entry covers 1999-2018

27 factory 25 guideline

Published source

Yamaha XJR1300 Owner's Manual 5WM-28199-E7 (English), Periodic maintenance charts pp.6-2 to 6-6

Factory owner's handbook. Covers 2010 (XJR1300, EU owner's manual 5WM-28199-E7, printed Nov 2009).

Open the source

52 items for a 2004 model, grouped by interval the way a factory chart is laid out.

How this bike is built (what the schedule is based on)

Engine cycle: Four-stroke
Engine lubrication: Wet sump (oil in crankcase)
Oil filtration: Replaceable cartridge or spin-on filter
Valve gear: Overhead cam, shim adjusted (incl. desmo)
Ignition: Electronic (CDI / transistor / ECU)
Charging: Alternator / stator with rectifier
Battery: Wet cell (flooded lead-acid, needs topping up)
Fuel system: Fuel injection
Cooling: Air / oil cooled
Primary drive: Gear or chain inside engine, shares engine oil
Gearbox oil: Shares engine oil
Clutch control: Hand lever, cable
Final drive: Chain
Front suspension: Telescopic fork
Rear suspension: Swingarm, single shock / cantilever
Front brake: Disc, hydraulic
Rear brake: Disc, hydraulic
Wheels: Cast / alloy, tubeless
Sidecar: No sidecar

Maintenance schedule

2004 Yamaha XJR 1300

On the road: every 200 mi

1 item

Check engine oil level

Pre-ride / on the road

Guideline

Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.

On the road: every 300 mi

2 items

Check lights, horn, brake light switches

Pre-ride / on the road

Guideline
Check tire pressures

Pre-ride / on the road

Guideline

On the road: every 600 mi

2 items

Check chain slack and rear wheel alignment

Pre-ride / on the road

Guideline
Lubricate drive chain

Pre-ride / on the road

Factory

Manual: Drive chain (check slack, alignment; adjust and lubricate). Factory: Every 1000 km (600 mi) and after washing or riding in rain

Every 3,000 mi or 12 months

3 items

Clean drive chain thoroughly (remove and soak, re-lube)

Final drive

Guideline

Non O-ring chains on old machines: remove, clean, soak in hot chain grease or lube, refit with the master link clip closed end leading.
Inspect chain and sprockets for wear (measure stretch)

Final drive

Guideline
Check footrests, pegs, rear brake and gear lever pivots

Rear suspension and frame

Guideline

Every 4,000 mi or 12 months

1 item

Adjust clutch free play, lubricate cable and lever pivot

Primary and gearbox

Guideline

Every 6,000 mi or 12 months

12 items

Air induction system (check cut-off valve, reed valve, hose)

Engine

Factory

Factory: 10000km columns and annual check
Change engine oil

Engine

Factory

Manual: Engine oil (change). Factory: Cols 1000km(600mi) initial, then 10000km(6000mi) spacing to 40000km; annual check
Chassis fasteners (check tightness)

Engine

Factory

Factory: 10000km columns and annual check
Check throttle cable(s) free play and return

Fuel and air

Factory

Manual: Throttle grip housing and cable (check free play, lubricate). Factory: 10000km columns and annual check
Clean / inspect air filter

Fuel and air

Guideline

Mesh or oiled foam: clean and re-oil. Paper: blow out or replace. Some very early machines have no filter at all.
Synchronize throttle bodies

Fuel and air

Factory

Manual: Fuel injection system (adjust synchronization). Factory: 10000km columns and annual check
Check charging voltage and regulator / cut-out

Ignition and electrics

Guideline
Grease and check center / side stand and springs

Rear suspension and frame

Factory

Manual: Sidestand, centerstand (check operation, lubricate). Factory: 10000km columns and annual check
Check brake pads and discs

Brakes

Factory

Manual: Front/rear brake (check operation, fluid level, leakage). Factory: Every column incl. initial; pads replaced whenever worn to limit
Inspect tire tread, sidewalls and date codes

Wheels and tires

Factory

Manual: Tires (check tread depth, damage, pressure). Factory: 10000km columns and annual check
Lubricate control cables and lever pivots

Controls and cables

Factory

Manual: Moving parts and cables; lever and pedal pivots (lubricate). Factory: 10000km columns and annual check
Lubricate speedometer / tachometer cables, check drive

Controls and cables

Guideline

A dry speedo cable whips the needle and eventually kills the instrument.

Every 6,000 mi

7 items

Muffler and exhaust pipe (check screw clamp)

Engine

Factory

Factory: Marked 1000km initial, then every 10000km
Clutch (check operation, fluid level and leakage)

Primary and gearbox

Factory

Factory: Marked 1000km initial, then every 10000km
Check steering head bearing adjustment

Front end

Factory

Manual: Steering bearings (check play and roughness). Factory: Marked 1000km initial, then every 10000km
Inspect fork seals, stanchions and fork boots

Front end

Factory

Manual: Front fork (check operation and oil leakage). Factory: 10000km columns
Check swingarm bushes for play

Rear suspension and frame

Factory

Manual: Swingarm (check operation and excessive play). Factory: 10000km columns
Inspect rear shocks for leaks and damping

Rear suspension and frame

Factory

Manual: Shock absorber assembly (check operation and oil leakage). Factory: 10000km columns
Check wheel bearings for play

Wheels and tires

Factory

Manual: Wheel bearings (check looseness or damage). Factory: 10000km columns

Every 10,000 mi or 2 years

1 item

Compression test (or leak-down)

Engine

Guideline

Every 12,000 mi or 2 years

1 item

Clean and grease rear suspension linkage

Rear suspension and frame

Guideline

Every 12,000 mi

5 items

Check and adjust valve clearances

Engine

Factory

Manual: Valves (check clearance, adjust). Factory: Every 20000 km (12000 mi); from 50000km repeat from 10000km
Inspect, clean and gap spark plugs

Engine

Factory

Manual: Spark plugs (check condition, clean and regap). Factory: Marked at 10000km and 30000km
Replace oil filter

Engine

Factory

Manual: Engine oil filter element (replace). Factory: Marked 1000km initial, 20000km, 40000km
Replace spark plugs

Engine

Factory

Manual: Spark plugs (replace). Factory: Marked at 20000km and 40000km
Repack / replace steering head bearings

Front end

Factory

Manual: Steering bearings (lubricate, lithium-soap grease). Factory: Every 20000 km (12000 mi)

Every 15,000 mi or 3 years

1 item

Change fork oil

Front end

Guideline

Some early telescopic forks are grease filled or use very small oil quantities. Check your manual.

Every 15,000 mi or 4 years

1 item

Check valve clearances (shim adjusted)

Engine

Guideline

Every 18,000 mi

1 item

Replace chain and sprockets (wear based)

Final drive

Guideline

Every 20,000 mi or 4 years

1 item

Repack / replace wheel bearings

Wheels and tires

Guideline

Cup-and-cone and taper roller hubs need periodic repacking and adjustment.

Every 24,000 mi or 4 years

1 item

Replace fuel filter

Fuel and air

Guideline

Every 24,000 mi

1 item

Replace air filter element

Fuel and air

Factory

Manual: Air filter element (replace). Factory: Marked at 40000km (24000mi) only

Every 25,000 mi or 6 years

1 item

Replace swingarm bushes / bearings

Rear suspension and frame

Guideline

Every 30,000 mi or 6 years

1 item

Rebuild forks: seals, bushes, springs

Front end

Guideline

Every 30,000 mi

1 item

Grease swingarm pivot

Rear suspension and frame

Factory

Manual: Swingarm (lubricate, lithium-soap grease). Factory: Every 50000 km (30000 mi)

Every 6 months

1 item

Clean battery terminals, check charge and strap

Ignition and electrics

Guideline

Every 2 years

4 items

Inspect wiring, bullet connectors and ground points

Ignition and electrics

Guideline
Inspect frame, welds and lugs for cracks

Rear suspension and frame

Guideline
Rebuild calipers and master cylinders (seals)

Brakes

Factory

Manual: Brake and clutch master/caliper/release cylinder internals (replace). Factory: Every two years (TIP under chart)
Replace brake fluid

Brakes

Factory

Manual: Brake and clutch fluids (change). Factory: Every two years (TIP under chart)

Every 4 years

2 items

Replace fuel lines

Fuel and air

Guideline

Old rubber and modern ethanol fuel do not mix well.
Inspect brake hoses; replace old rubber

Brakes

Factory

Manual: Brake hoses (replace). Factory: Every 4 years; checked every 10000km and annually

Every 6 years

1 item

Replace tires on age (regardless of tread)

Wheels and tires

Guideline

Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.