MotoService Log
No photo of this model in the library yet.
Kymco · Overhead-cam four-stroke single, wet sump, separate gearbox oil, CVT belt drive

Agility 50

Library entry covers 2006-2025

13 factory 39 guideline

Published source

Kymco Agility 50 (four-stroke) Manual de usuario (Spanish, Kymco Spain), Tabla de mantenimiento p.055 (factory PDF, copy on archive.org)

Factory owner's handbook. Covers Agility 50 four-stroke, Spanish-market manual.

Open the source

52 items for a 2011 model, grouped by interval the way a factory chart is laid out.

How this bike is built (what the schedule is based on)
Engine cycle
Four-stroke
Engine lubrication
Wet sump (oil in crankcase)
Oil filtration
Replaceable cartridge or spin-on filter
Valve gear
Overhead cam, screw/locknut adjusters
Ignition
Electronic (CDI / transistor / ECU)
Charging
Alternator / stator with rectifier
Battery
Wet cell (flooded lead-acid, needs topping up)
Fuel system
Fuel injection
Cooling
Air / oil cooled
Primary drive
Gear or chain inside engine, shares engine oil
Gearbox oil
Separate gearbox oil
Clutch control
Automatic or semi-automatic
Final drive
Belt CVT, scooter automatic
Front suspension
Telescopic fork
Rear suspension
Swingarm, single shock / cantilever
Front brake
Disc, hydraulic
Rear brake
Drum (or band / belt rim)
Wheels
Cast / alloy, tubeless
Sidecar
No sidecar
Maintenance schedule

2011 Kymco Agility 50

On the road: every 200 mi

1 item
  • Check engine oil level
    Pre-ride / on the road
    Guideline

    Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.

On the road: every 300 mi

1 item
  • Check lights, horn, brake light switches
    Pre-ride / on the road
    Guideline

On the road: every 2,485 mi

1 item
  • Check tire pressures
    Pre-ride / on the road
    Factory

    Manual: PRESIÓN DE LOS NEUMÁTICOS. Factory: C at 300, 3k, 7k, 11k km; daily check.

Every 621 mi

1 item
  • Clean / inspect air filter
    Fuel and air
    Factory

    Manual: FILTRO DEL AIRE. Factory: Clean every 1,000 km.

Every 1,000 mi or 6 months

2 items
  • Adjust rear drum brake and rod / cable linkage
    Brakes
    Guideline
  • Inspect tire tread, sidewalls and date codes
    Wheels and tires
    Guideline

Every 1,243 mi

3 items
  • Change engine oil
    Engine
    Factory

    Manual: ACEITE MOTOR. Factory: S at 300, 1,000 km then every 2,000 km; check daily. Cols 300/1.000/3.000/5.000/7.000/9.000/11.000/13.000 km.

  • Inspect, clean and gap spark plugs
    Engine
    Factory

    Manual: BUJÍA. Factory: Clean every 2,000 km.

  • Replace air filter element
    Fuel and air
    Factory

    Manual: FILTRO DEL AIRE. Factory: Replace every 2,000 km.

Every 2,485 mi or 12 months

1 item
  • Change final drive (rear drive) oil
    Final drive
    Factory

    Manual: ACEITE CAJA REDUCTORA. Factory: S at 300/1k/3k/7k/11k; note 2 says every year or 10,000 km.

Every 2,485 mi

5 items
  • Check and adjust valve clearances
    Engine
    Factory

    Manual: JUEGO DE VÁLVULAS. Factory: A at 300, 3k, 7k, 11k km.

  • Clean oil strainers / mesh screens
    Engine
    Factory

    Manual: TAMIZ FILTRO ACEITE MOTOR. Factory: L (clean) at 300, 3k, 7k, 11k km.

  • CARBURADOR
    Fuel and air
    Factory

    Factory: C at 3k, 7k, 11k km.

  • Inspect drive belt, pulleys and tension
    Final drive
    Factory

    Manual: CORREA VARIADOR. Factory: C at 7k and 13k; note 3: check every 4,000 km after replacement.

  • Check brake pads and discs
    Brakes
    Factory

    Manual: SISTEMA DE FRENOS. Factory: C at 300, 3k, 7k, 11k km; daily check.

Every 3,000 mi or 12 months

7 items
  • Check throttle cable(s) free play and return
    Fuel and air
    Guideline
  • Adjust automatic / semi-automatic clutch
    Primary and gearbox
    Guideline
  • Check steering head bearing adjustment
    Front end
    Guideline
  • Inspect fork seals, stanchions and fork boots
    Front end
    Guideline
  • Check footrests, pegs, rear brake and gear lever pivots
    Rear suspension and frame
    Guideline
  • Grease and check center / side stand and springs
    Rear suspension and frame
    Guideline
  • Check wheel bearings for play
    Wheels and tires
    Guideline

Every 3,107 mi

1 item
  • Replace spark plugs
    Engine
    Factory

    Manual: BUJÍA. Factory: Replace every 5,000 km.

Every 4,000 mi or 12 months

2 items
  • Inspect CVT drive belt, rollers / sliders and clutch shoes
    Final drive
    Guideline

    Typical scooter interval. Your owner's manual figure governs; check belt width against the service limit.

  • Lubricate brake cam spindles, check linings and drums
    Brakes
    Guideline

Every 5,000 mi or 12 months

1 item
  • Replace oil filter
    Engine
    Guideline

Every 6,000 mi or 12 months

5 items
  • Check charging voltage and regulator / cut-out
    Ignition and electrics
    Guideline
  • Check swingarm bushes for play
    Rear suspension and frame
    Guideline
  • Inspect rear shocks for leaks and damping
    Rear suspension and frame
    Guideline
  • Lubricate control cables and lever pivots
    Controls and cables
    Guideline
  • Lubricate speedometer / tachometer cables, check drive
    Controls and cables
    Guideline

    A dry speedo cable whips the needle and eventually kills the instrument.

Every 10,000 mi or 2 years

2 items
  • Compression test (or leak-down)
    Engine
    Guideline
  • Change gearbox oil
    Primary and gearbox
    Guideline

Every 12,000 mi or 2 years

3 items
  • Synchronize throttle bodies
    Fuel and air
    Guideline
  • Clean and grease rear suspension linkage
    Rear suspension and frame
    Guideline
  • Grease swingarm pivot
    Rear suspension and frame
    Guideline

Every 12,000 mi or 3 years

1 item
  • Replace CVT drive belt
    Final drive
    Guideline

    Typical scooter interval, or sooner if the belt is cracked, glazed or below its width limit.

Every 15,000 mi or 3 years

1 item
  • Change fork oil
    Front end
    Guideline

    Some early telescopic forks are grease filled or use very small oil quantities. Check your manual.

Every 15,000 mi

1 item
  • Replace brake linings / skim drums (wear based)
    Brakes
    Guideline

Every 20,000 mi or 4 years

2 items
  • Repack / replace steering head bearings
    Front end
    Guideline

    Many old machines use loose balls in cups and cones. Taper roller conversions are common.

  • Repack / replace wheel bearings
    Wheels and tires
    Guideline

    Cup-and-cone and taper roller hubs need periodic repacking and adjustment.

Every 24,000 mi or 4 years

1 item
  • Replace fuel filter
    Fuel and air
    Guideline

Every 25,000 mi or 6 years

1 item
  • Replace swingarm bushes / bearings
    Rear suspension and frame
    Guideline

Every 30,000 mi or 6 years

1 item
  • Rebuild forks: seals, bushes, springs
    Front end
    Guideline

Every 6 months

1 item
  • Clean battery terminals, check charge and strap
    Ignition and electrics
    Guideline

Every 2 years

3 items
  • Inspect wiring, bullet connectors and ground points
    Ignition and electrics
    Guideline
  • Inspect frame, welds and lugs for cracks
    Rear suspension and frame
    Guideline
  • Replace brake fluid
    Brakes
    Factory

    Manual: Líquido de frenos (nota 4). Factory: Note 4: replace brake fluid every two years.

Every 4 years

3 items
  • Replace fuel lines
    Fuel and air
    Guideline

    Old rubber and modern ethanol fuel do not mix well.

  • Inspect brake hoses; replace old rubber
    Brakes
    Guideline
  • Rebuild calipers and master cylinders (seals)
    Brakes
    Guideline

Every 6 years

1 item
  • Replace tires on age (regardless of tread)
    Wheels and tires
    Guideline

Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.

Keep up with this schedule on your phone

Add the bike in the app and this chart loads itself, ready to log against and edit.

Coming soon to Google Play

Other 2011 Kymco models

All 2011 Kymco