
High Ball (1737 cc)
Library entry covers 2012-2018
Published source
Victory 2013 Owner's Manual (Hammer / Vegas / High-Ball / Judge / Boardwalk), Periodic Maintenance Table p.50
Factory owner's handbook. Covers 2013 Hammer, Hammer 8-Ball, Vegas Jackpot, Vegas 8-Ball, High-Ball, Judge, Boardwalk.
Open the source44 items for a 2016 model, grouped by interval the way a factory chart is laid out.
How this bike is built (what the schedule is based on)
- Engine cycle
- Four-stroke
- Engine lubrication
- Wet sump (oil in crankcase)
- Oil filtration
- Replaceable cartridge or spin-on filter
- Valve gear
- Hydraulic lifters (no routine clearance adjustment)
- Ignition
- Electronic (CDI / transistor / ECU)
- Charging
- Alternator / stator with rectifier
- Battery
- Wet cell (flooded lead-acid, needs topping up)
- Fuel system
- Fuel injection
- Cooling
- Air / oil cooled
- Primary drive
- Gear or chain inside engine, shares engine oil
- Gearbox oil
- Shares engine oil
- Clutch control
- Hand lever, cable
- Final drive
- Toothed belt
- Front suspension
- Telescopic fork
- Rear suspension
- Swingarm, single shock / cantilever
- Front brake
- Disc, hydraulic
- Rear brake
- Disc, hydraulic
- Wheels
- Cast / alloy, tubeless
- Sidecar
- No sidecar
2016 Victory High Ball (1737 cc)
On the road: every 200 mi
1 item-
Check engine oil levelPre-ride / on the roadGuideline
Each fuel stop on old machines. Dry sump: check the tank hot, engine idling or just stopped, per your manual.
On the road: every 300 mi
2 items-
Check lights, horn, brake light switchesPre-ride / on the roadGuideline
-
Check tire pressuresPre-ride / on the roadGuideline
Every 3,000 mi or 12 months
2 items-
Inspect fork seals, stanchions and fork bootsFront endGuideline
-
Check wheel bearings for playWheels and tiresGuideline
Every 5,000 mi or 12 months
2 items-
Change engine oilEngineFactory
Manual: Engine Oil. Factory: R at 500 mi (800 km) then every 5,000 mi; replace at interval or annually.
-
Replace oil filterEngineFactory
Manual: Engine Oil Filter. Factory: R at 500 mi then every 5,000 mi (8,000 km), or annually.
Every 5,000 mi
9 items-
Inspect, clean and gap spark plugsEngineFactory
Manual: Spark Plugs. Factory: Inspect every service column except replacement.
-
Clean / inspect air filterFuel and airFactory
Manual: Air Filter. Factory: Inspect at 500 mi then 5,000-mile columns between replacements.
-
Clean battery terminals, check charge and strapIgnition and electricsFactory
Manual: Battery. Factory: Inspect every service column.
-
Inspect drive belt, pulleys and tensionFinal driveFactory
Manual: Drive Belt. Factory: Inspect every service column.
-
Check steering head bearing adjustmentFront endFactory
Manual: Steering Head Bearings. Factory: Inspect every service column.
-
Check swingarm bushes for playRear suspension and frameFactory
Manual: Swing Arm and Rear Axle. Factory: Inspect every service column.
-
Check brake pads and discsBrakesFactory
Manual: Brake Pads. Factory: Inspect every service column.
-
Check spoke tension and wheel trueWheels and tiresFactory
Manual: Wheel Spokes. Factory: Inspect every service column.
-
Inspect tire tread, sidewalls and date codesWheels and tiresFactory
Manual: Tires. Factory: Inspect every service column.
Every 6,000 mi or 12 months
4 items-
Check charging voltage and regulator / cut-outIgnition and electricsGuideline
-
Inspect rear shocks for leaks and dampingRear suspension and frameGuideline
-
Lubricate control cables and lever pivotsControls and cablesGuideline
-
Lubricate speedometer / tachometer cables, check driveControls and cablesGuideline
A dry speedo cable whips the needle and eventually kills the instrument.
Every 10,000 mi
6 items-
Compression test (or leak-down)EngineFactory
Manual: Engine Compression. Factory: Inspect at 500 mi then every 10,000 mi.
-
Check throttle cable(s) free play and returnFuel and airFactory
Manual: Throttle System. Factory: Lubricate every 10,000 mi; inspect at 5,000-mile columns.
-
Replace air filter elementFuel and airFactory
Manual: Air Filter. Factory: R every 10,000 mi; every 5,000 mi (8,000 km) in dusty conditions.
-
Adjust clutch free play, lubricate cable and lever pivotPrimary and gearboxFactory
Manual: Clutch Cable / Clutch Lever. Factory: Lubricate every 10,000 mi; inspect at 5,000-mile columns.
-
Check footrests, pegs, rear brake and gear lever pivotsRear suspension and frameFactory
Manual: Gear Shift Pedal / Rear Brake Pedal. Factory: Lubricate every 10,000 mi; inspect at 5,000-mile columns.
-
Grease and check center / side stand and springsRear suspension and frameFactory
Manual: Sidestand. Factory: Lubricate every 10,000 mi; inspect at 5,000-mile columns.
Every 12,000 mi or 2 years
3 items-
Synchronize throttle bodiesFuel and airGuideline
-
Clean and grease rear suspension linkageRear suspension and frameGuideline
-
Grease swingarm pivotRear suspension and frameGuideline
Every 15,000 mi or 2 years
1 item-
Change fork oilFront endFactory
Manual: Front Fork Oil. Factory: R at 15,000/30,000/45,000 mi, or every 2 years.
Every 15,000 mi
1 item-
Repack / replace steering head bearingsFront endFactory
Manual: Steering Head Bearings. Factory: L (lubricate) at 15,000/30,000/45,000 mi columns.
Every 20,000 mi or 4 years
1 item-
Repack / replace wheel bearingsWheels and tiresGuideline
Cup-and-cone and taper roller hubs need periodic repacking and adjustment.
Every 25,000 mi or 6 years
1 item-
Replace swingarm bushes / bearingsRear suspension and frameGuideline
Every 25,000 mi
1 item-
Replace fuel filterFuel and airFactory
Manual: Fuel Filter. Factory: R at 25,000 and 50,000 mi columns.
Every 30,000 mi or 2 years
1 item-
Replace brake fluidBrakesFactory
Manual: Brake Fluid. Factory: R at 30,000 mi column, or every 2 years; inspect each service.
Every 30,000 mi or 6 years
1 item-
Rebuild forks: seals, bushes, springsFront endGuideline
Every 30,000 mi
2 items-
Replace spark plugsEngineFactory
Manual: Spark Plugs. Factory: R at 30,000 mi column; inspect other columns.
-
Replace drive belt (wear or damage based)Final driveFactory
Manual: Drive Belt. Factory: R (replace/rebuild) marked at the 30,000 mi (48,000 km) column.
Every 2 years
2 items-
Inspect wiring, bullet connectors and ground pointsIgnition and electricsGuideline
-
Inspect frame, welds and lugs for cracksRear suspension and frameGuideline
Every 4 years
3 items-
Replace fuel linesFuel and airGuideline
Old rubber and modern ethanol fuel do not mix well.
-
Inspect brake hoses; replace old rubberBrakesGuideline
-
Rebuild calipers and master cylinders (seals)BrakesGuideline
Every 6 years
1 item-
Replace tires on age (regardless of tread)Wheels and tiresGuideline
Guideline lines: Intervals here are general guidelines for the machine's era and layout, compiled for this app. They are not factory manual figures. Check your workshop manual, and edit any interval in the bike's Schedule tab.
Keep up with this schedule on your phone
Add the bike in the app and this chart loads itself, ready to log against and edit.